GRP blade holder, 5 mm ∅ hole

Référence: 72/1

Frein rotor en CFK

When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments. Pease note: stay in safe distance away from the turning...

Référence: 832/47

Joint torique 5 x 9 mm

O-ring 5 x 9 mm Content of the package: 2 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Référence: 704/31

4-blade centre piece, 10 mm

Item to a multi-blade rotor head for Ø 10 mm shaft; see Ord.No. 703/30, 704/30 and 705/30.

Référence: 702/76

GRP blade holder, 22 mm blade throat

This blade holder was specially developed for the large Bell 47 G III with a rotor diameter of 2.36 m. It has a 22 mm blade throat and a 6 mm Ø bore for the retaining screw, i.e. the matching blade holder screws and self-locking nuts are M6 in size.

Référence: 71/27

Goupille avec circlips

Pivot pin with circlipContent of the package 2 pieces

Référence: 703/31

3-blade centre piece, 10 mm

Item to a multi-blade rotor head for Ø 10 mm shaft; see Ord.No. 703/30, 704/30 and 705/30.

Référence: 76/10

Blade holder, aluminium

Blade holder, aluminium, alone.

Référence: 702/96

Inertia weights

set of 2

Référence: 704/33

4-blade centre piece 12 mm

Component part for a multi-blade rotor head for 12 mm Ø main shaft; see Ord.No. 703/32, 704/32 resp. 705/32.

Référence: 703/45

Rotor head linkage for Alouette III

This rotor head linkage is essential for the correct operation of the rotor head of the Alouette III due to its heavy take-off weight.

Référence: 74/17

Joint torique, souple 2,5 x 13 mm

O-ring 2.5 x 13 mm soft Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Référence: 91/65

Paddles 3-D

 Paddles1 pairapprox. 19 g eachfor 4 mm Ø flybar

Référence: 72/3

Rotor brake, GRP, red

When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments.Please note: stay in safe distance away from the turning...

Référence: 702/90

Aluminium centre piece

Aluminium centre piece for 12 mm Ø main shaft

Référence: 703/72

Eje de rodamiento de cuchillas para cabezal de 3 cuchillas

Référence: 54/16

Clamp ring pitch compensator 17 mm

The 17 mm Ø clamp ring is fitted to the rotor head centre piece, the steel pin slides in the guide slot of the pitch compensator. Rotate the clamp for fine adjustment so that your helicopter flies straight when you apply a pitch-axis command.Clamp ring for pitch compensator 17 mm Ø, length of the pin 30 mm.