Gear support for tail drive

Riferimento: 715/40

Canopy retainer

 Content of the package2 pieces

Riferimento: 33/27

Rotor blade tie-down large

The rotor blade harness ranks as an essential accessory for full-size helicopters. These items prevent the blades swinging or rocking, and thereby exerting pressure on the rotor shaft. If that were to be allowed, in-flight failures could be attributed to it.Rotor blades set in motion by rising winds could also be damaged by striking obstacles. The rotor...

Riferimento: 15/8

Charge lead MPX high current plug 2.5 mm²

Not available

Riferimento: 13/21

Magnets for speed regulator

These magnets are suitable for use with all commercial speed regulators. For installation in the mechanics it is advisable the magnets be glued in a clamp ring Ord.No. 54/6, or as in the photo on the internal-tooth gear ring. Pack of 3

Riferimento: 1414

Battery Switch

Dual power supply with gas cap switch

Riferimento: 1413

Electronic switch harness

Not available

Riferimento: 18/11

Aluminium tube 5.5 x 4.4 x 1000 mm

Aluminium tube 5.5 x 4.4 x 1000 mm

Riferimento: 33/22

Rotor blade support

If you do not wish to remove the rotor blades temporarily for transport, they can be protected effectively in this strong support, which is mounted above the tail boom.The height of the support, the width of the blade openings and the diameter of the tail boom are the crucial factors when buying a blade support.This support is ideal for pod-and-boom...

Riferimento: 603/23

Internal damper

 Content of the package2 pieces

Riferimento: 21/20

Pushrod 1.2 x 1200 mm, steel

Pushrod 1.2 x 1200 mm, steel

Riferimento: 17/2

Steel guide 6.2 x 10 mm

Content of the package 1 piece

Riferimento: 18/9

PVC tube 4.5 x 3.3 x 380 mm, white

PVC tube 4.5 x 3.3 x 380 mm, white

Riferimento: 305/18

Halter Kugellager

Riferimento: 10/75

Glue dispenser

When you insert cartridges Ord.No. 10/73 into the dispenser and press the components through the mixing nozzle the epoxy is ready for immediate use.

Riferimento: 3948

Servo numbers

Cable spaghetti? We all know the problem of allocating the servo leads to the receiver outputs. Here's the answer: number them like the pro's do! Simply put the receiver channel number on each lead; they can be removed just as easily. The pack contains three sets of 10, numbered from 0-9, in different colours.Servo numbers, pack of 30

Riferimento: 33/5

Rotorblatttasche 5-Blatt max Ø 2500 mm