Bordtelefon 1:4

Riferimento: 341/509

BTP Lama 1:5

dimensions: main part: 9.5 x 4.95 x 6.4 cm6-part

Riferimento: 340/6

Pedana di salita per Lama

If you have a mind to continue adding detail fittings to your Lama, you are sure to appreciate this landing gear step which can be fitted to an existing model at any time. The step is made of stainless steel, and is supplied complete with clips, screw fittings and tread material. Entry step, for Lama, pack of 1

Riferimento: 1/21

Helmet for pilot William

As you would expect, we can also supply the matching type of GRP helmet for William the Pilot; it is simply pushed into place on his head. If you wish to fit a radio headpiece, you now have plenty of scope for your imagination: a piece of foam rubber, a thin wire mount and a coiled cable are all you need to make this accessory, and the pilot will...

Riferimento: 341/421

Rueda de ventilador Lama 1: 4

Riferimento: 341/508

Serbatio olio piccolo Lama 1/4

dimensions: 5.45 x 1.66 x 5.36 cm

Riferimento: 341/414

Lama 1: 4 luz anticolisión trasera

Riferimento: 341/419

Tendicinghia pulegge, 6 pz Lama 1/4

1,18 x 3,15 x 0,72 cmPack of 6

Riferimento: 341/411

Llama estabilización trasera 1: 4

Riferimento: 330/10

Protezione capottina per Lama

This protective sheath provides effective protection to the cabin of your valuable helicopter, and helps to avoid unsightly scratches. It is simply pulled over the cabin and closed with a hook -and-loop fastener.Cabin sheath for Lamamatching the cabins of the models 3300 and 3400

Riferimento: 341/36

CESTELLO SOTTOPANCIA PER LAMA

Load basket for Lamalength:410 mmwidth:100 mmheight70 mm

Riferimento: 341/406

Scatola Fusibili Electric Box Lama 1:4

dimensions: 12.6 x 7 x 4.3 cm2-part

Riferimento: 341/405

Pitot 41:4

dimensions: 5.7 x 1.7 x 2.5 cm

Riferimento: 330/2

Imitazione turbina

The dummy turbine provides the ideal starting point if you wish to install additional scale fittings on your Lama.The dummy turbine is assembled from six separate GRP mouldings, and fits all models with VR-22 mechanics installed.In the turbine-powered version of the Lama the actual turbine is located in this position.GRP dummy turbineLength approx. 490 mm

Riferimento: 330/5

Set accessori portelli per Bell 47 G III, Lama

Door fittings for large-scale model helicopters do not differ fundamentally from one type to another. However, the size of these accessories is important if the model is to look convincing, otherwise they will look out of scale.Compare the door handle of the Lama with that of the Alouette II, and the difference is obvious.The door fittings set for the...

Riferimento: 10/96

Anti-collision light with red housing

Riferimento: 340/5

Snowboards per Lama 1 paio

When full-size helicopters have to land in deep snow, the skids are fitted with "snowboards" to prevent them sinking in.On the model they look really good, and also help the pilot detect the model's orientation in the air.Make your model an eye-catcher and use some rivets for the decoration of the skies."Snowboards" for Lama, 1 pair