Kabel-Umlenkrollen Lama x6 1:4

Référence: 341/429

Panneau de cockpit détaillé pour Lama

Addition to the Cockpit Ord. No. 340/29 to make it look more realistic

Référence: 1/21

Casque pour Pilote William 1:4

As you would expect, we can also supply the matching type of GRP helmet for William the Pilot; it is simply pushed into place on his head. If you wish to fit a radio headpiece, you now have plenty of scope for your imagination: a piece of foam rubber, a thin wire mount and a coiled cable are all you need to make this accessory, and the pilot will...

Référence: 341/409

BTP Lama 1: 4

Référence: 340/1

Support de roue pour Lama

The Lama is a large helicopter, and the supplementary wheels which can be attached to the landing gear make it much easier to move the machine into and out of the hangar. However, the wheels are removed prior to flying the model. These wheel holders for our model of the Lama are made of plastic and are simply glued to the 20 mm Ø skid tubes using UHU...

Référence: 341/405

Tube pitot Lama 1:4

dimensions: 5.7 x 1.7 x 2.5 cm

Référence: 10/96

Anti-collision light with red housing

Référence: 341/36

Panier de transport, 1 pièce

Load basket for Lamalength:410 mmwidth:100 mmheight70 mm

Référence: 134/411

Antena alrededor de 1: 4

Référence: 134/460

Telephone de bord 1:4

dimensions: 1.9 x 1.2 x 6.3 cm

Référence: 341/413

Essuie glace 1:4

dimensions: 10.63 x 0.7 x 1.3 cmPack of 2, each 2-part

Référence: 341/406

Boitier électrique Lama 1:4

dimensions: 12.6 x 7 x 4.3 cm2-part

Référence: 341/415

Llamada de rescate por radar x2 1: 4

Référence: 341/403

Trappes de visite avant Lama 1:4

dimensions: 6 x 8.2 x 0.5 cm2-part

Référence: 330/5

Kit accessoires portes Bell 47 G III, Lama

Door fittings for large-scale model helicopters do not differ fundamentally from one type to another. However, the size of these accessories is important if the model is to look convincing, otherwise they will look out of scale.Compare the door handle of the Lama with that of the Alouette II, and the difference is obvious.The door fittings set for the...

Référence: 341/411

Llama estabilización trasera 1: 4

Référence: 340/5

Protection contre l'enlisement pour Lama

When full-size helicopters have to land in deep snow, the skids are fitted with "snowboards" to prevent them sinking in.On the model they look really good, and also help the pilot detect the model's orientation in the air.Make your model an eye-catcher and use some rivets for the decoration of the skies."Snowboards" for Lama, 1 pair