Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Stainless steel exhaust manufactured specifically for the Bell 429
Política de seguridad
Política de envío
Política de devolución
Stainless steel exhaust manufactured specifically for the Bell 429
No hay reseñas de clientes en este momento.
Riferimento: 434/16
On the AIRWOLF, Bell 230 and Bell 430 the forward thrust is eliminated by the scale division of the exhaust tube (enlarging of the cross-section) and exhausting up through the rotor disc.
Riferimento: 25/9
Between fuselage and exhaust tube a heat-reflecting mat avoids melting of the fibreglass. Even in smaller fuselages where conventional silencer systems are close to the inside surface, the heat reflective mat is useful as a heat shield.Heat reflective matheat rejectingsize approx. 300 x 700 mmmat thickness approx. 3 mm
Riferimento: 214/16
Exhaust tubes for turbines are always designed for the specified model. It is important that no forward thrust emerges from the system. Should this still occur, the forward thrust produced is minimal.Turbine exhaust tubes are designed as exhaust-gas diffusers, i.e. opens wider towards the rear.
Riferimento: 206/16
This exhaust system is designed for the UH-1D with turbine power system.Exhaust tubes for turbines are always designed for the specified model. It is important that no forward thrust emerges from the system. Should this still occur, the forward thrust produced is minimal.Turbine exhaust tubes are designed as exhaust-gas diffusers, i.e. opens wider towards...
Riferimento: 641/16
right / leftThis exhaust system is designed for the Air-Crane with turbine power system.
Riferimento: 520/16
The outlets on the left and right hand sides offer the necessary cross-section and greatly reduce the forward thrust.This keeps the scale rear outlet while only discharging a small amount of the total exhaust gas.
Riferimento: 904/16
The shape and dimensions of the Hughes fuselages allow for the installation of a three outlet exhaust. The outlets on the left and right hand sides offer the necessary cross-section and greatly reduce the forward thrust. This keeps the scale rear outlet while only discharging a small amount of the total exhaust gas.
Riferimento: 930/16
right / leftThis exhaust system is designed for the Mil Mi-2 with turbine power system.
Riferimento: 340/16
This exhaust system is designed for the Lama with turbine power system.
Stainless steel exhaust manufactured specifically for the Bell 429
