Home
Marchi

Nessuna marca

Fornitori
Migliori vendite
Flanged ballrace 6 x 10 x 3 mm Anteprima

Riferimento: 92/91

Flanged ballrace 6 x 10 x 3 mm

Recensioni: 0

Ballraces are used wherever moving parts are required to run with a minimum of play and a minimum of friction. The more ballraces are used, the more smoothly the mechanics of a helicopter works, and the lower the rate of wear. The dimensions of a ballrace mean: inside diameter (I.D.) x outside diameter (O.D.) x thickness. For flanged bearings the same...

Prezzo 14,70 €
Più
In vendita su richiesta
Aste 3,0 x 75 mm Anteprima

Riferimento: 70/76

Aste 3,0 x 75 mm

Recensioni: 0

Ready-made pushrod, threaded M 3. Content of the package: 1 piece

Prezzo 6,30 €
Più
In vendita su richiesta
Tutte le migliori vendite

Viti a brugola per fissaggio pale coda M3 x 20 G12

054
Valutazione 

Bolt using self-locking nuts don't need additional screw-retaining fluid. Of course this applies to the blade holder bolts on the main rotor head and on the tail rotor (as shown here).
Blade holder bolts are counted among the special bolts with high tensile stength, where the shaft and thread length are matched to the application.

Pack of 2 with self-locking nuts M 3

4,70 €
Tasse incluse
Quantità
In vendita su richiesta

 

Política de seguridad

 

Política de envío

 

Política de devolución

Descrizione

Bolt using self-locking nuts don't need additional screw-retaining fluid. Of course this applies to the blade holder bolts on the main rotor head and on the tail rotor (as shown here).
Blade holder bolts are counted among the special bolts with high tensile stength, where the shaft and thread length are matched to the application.

Pack of 2 with self-locking nuts M 3

Dettagli del prodotto
054
Recensioni

Ancora nessuna recensione da parte degli utenti.

Scrivi la tua recensione

Viti a brugola per fissaggio pale coda M3 x 20 G12

Viti a brugola per fissaggio pale coda M3 x 20 G12

Bolt using self-locking nuts don't need additional screw-retaining fluid. Of course this applies to the blade holder bolts on the main rotor head and on the tail rotor (as shown here).
Blade holder bolts are counted among the special bolts with high tensile stength, where the shaft and thread length are matched to the application.

Pack of 2 with self-locking nuts M 3

Scrivi la tua recensione
16 otros productos en la misma categoría:
Tornillo rotor de cola... Vista rápida

Referencia: 059

Tornillo rotor de cola M4x26 G12

Reseña(s): 0

Paquete de 3 con tuercas autoblocantes M 4 Consejo: Para evitar perder esos tornillos del soporte de la cuchilla, empújelos directamente hacia atrás en los soportes de la cuchilla y coloque las tuercas sin apretar, de modo que sepa dónde están la próxima vez que monte el modelo.

Precio 9,70 €
Más
En venta bajo pedido

Seguici su Facebook

Facebook