Fissaggio magnetico

Reference: 341/424

Kick bar llama 2 partes 1: 4

Reference: 341/416

Espejo Lama 1: 4

Reference: 341/419

Cables Pulleys Lama x6 1:4

1,18 x 3,15 x 0,72 cmPack of 6

Reference: 1/21

Helmet for pilot William 1:4

As you would expect, we can also supply the matching type of GRP helmet for William the Pilot; it is simply pushed into place on his head. If you wish to fit a radio headpiece, you now have plenty of scope for your imagination: a piece of foam rubber, a thin wire mount and a coiled cable are all you need to make this accessory, and the pilot will...

Reference: 134/460

Telephone on board 1:4

dimensions: 1.9 x 1.2 x 6.3 cm

Reference: 341/406

Electric Box Lama 1:4

dimensions: 12.6 x 7 x 4.3 cm2-part

Reference: 134/410

Antena superior 1: 4

Reference: 341/417

Large mirror Lama 1:4

dimensions: 4 x 5.4 x 1 cm

Reference: 350/17

Exhaust cover, Ø 90 mm

When the turbine of a full-size helicopter is not running, the engine is protected with an exhaust cover which prevents foreign objects finding their way inside the turbine. This exhaust cover for model turbines is suitable for the Lama, Alouette III and any other machine with a 90 mm Ø exhaust pipe. Caution: it is essential to allow the exhaust pipes to...

Reference: 330/10

Cabin sheath for Lama

This protective sheath provides effective protection to the cabin of your valuable helicopter, and helps to avoid unsightly scratches. It is simply pulled over the cabin and closed with a hook -and-loop fastener.Cabin sheath for Lamamatching the cabins of the models 3300 and 3400

Reference: 340/6

Entry step, for Lama

If you have a mind to continue adding detail fittings to your Lama, you are sure to appreciate this landing gear step which can be fitted to an existing model at any time. The step is made of stainless steel, and is supplied complete with clips, screw fittings and tread material. Entry step, for Lama, pack of 1

Reference: 341/520

Battery housing /Lama

dimensions: 7.76 x 3.4 x 5.3 cm

Reference: 330/45

Hook for Lama

The hook for the Lama is fully functional. The scale aluminium frame comes with further more accessories, inclusive servo mount.The fuselage already offers the fastening, ready soldered.On your model you mount the hook in the required location, and release dummy loads by activating a servo via your transmitter.

Reference: 10/96

Anti-collision light with red housing

Reference: 341/429

Detailed Cockpit panel, Lama

Addition to the Cockpit Ord. No. 340/29 to make it look more realistic

Reference: 340/1

Wheel holder for Lama

The Lama is a large helicopter, and the supplementary wheels which can be attached to the landing gear make it much easier to move the machine into and out of the hangar. However, the wheels are removed prior to flying the model. These wheel holders for our model of the Lama are made of plastic and are simply glued to the 20 mm Ø skid tubes using UHU...