Spacer 4 x 6 x 1.5 mm

Riferimento: 71/28

Set orecchie e spinotti

Curved link, with pin

Riferimento: 702/76

GRP blade holder, 22 mm blade throat

This blade holder was specially developed for the large Bell 47 G III with a rotor diameter of 2.36 m. It has a 22 mm blade throat and a 6 mm Ø bore for the retaining screw, i.e. the matching blade holder screws and self-locking nuts are M6 in size.

Riferimento: 91/55

Lead for paddles

 Lead for paddlespack of 2approx. 8.5 g each

Riferimento: 117/20

Thrust bearing set complete

The standard version of our mechanics includes ground thrust bearing shafts with a of 8 mm Ø and a length of 110 mm.Thrust bearings absorb the high centrifugal forces exerted by the main rotor blades. The effect of the axial bearings is retained in full when the blade holders rotate.Thrust bearing set, complete as shown.

Riferimento: 72/22

Rotor head centre piece, rigid

Aluminium centre piece, rigid, for 12 mm main shaft

Riferimento: 76/8

Ballrace spacer, steel

Ballrace spacer, steel Content of the package: 1 piece.

Riferimento: 71/55

Collective pitch compensator 12 mm

Pitch compensator, complete, for 12 mm Ø main shaft, centre piece aluminium

Riferimento: 704/39

cabezal de rotor de 4 palas 15 mm

Riferimento: 74/19

OR 1,5 x 19 mm. tipo morbido

O-ring 1.5 x 19 mm soft Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Riferimento: 770/36

Spacer for rotor cap BK117

Not available

Riferimento: 832/75

Thrust washer

Thrust washer for rotor head Content of the package: 2 pieces

Riferimento: 702/15

15mm 2 blade centre piece

Aluminium centre piece for 15 mm Ø main shaft

Riferimento: 832/54

Clamp ring

Clamp ring for rotor head 722/72.

Riferimento: 71 A

Corpo centrale, compensatore di passo

Centre piece for pitchcompensator, GFK, alone.

Riferimento: 72/3

Rotor brake, GRP, red

When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments.Please note: stay in safe distance away from the turning...

Riferimento: 76/9

Portapala

Blade holder arm, aluminium. Content of the package: 1 piece.