Rotor blade tie-down

Référence: 33/66

Rotor blade pouch 2x3 blade max Ø 2500 mm

Référence: 1413

Electronic switch harness

Not available

Référence: 330/10

Housse de protection pour Lama

This protective sheath provides effective protection to the cabin of your valuable helicopter, and helps to avoid unsightly scratches. It is simply pulled over the cabin and closed with a hook -and-loop fastener.Cabin sheath for Lamamatching the cabins of the models 3300 and 3400

Référence: 21/20

Pushrod 1.2 x 1200 mm, steel

Pushrod 1.2 x 1200 mm, steel

Référence: 33/27

Rotor blade tie-down large

The rotor blade harness ranks as an essential accessory for full-size helicopters. These items prevent the blades swinging or rocking, and thereby exerting pressure on the rotor shaft. If that were to be allowed, in-flight failures could be attributed to it.Rotor blades set in motion by rising winds could also be damaged by striking obstacles. The rotor...

Référence: 33/6

Rotor blade pouch 2x3 blade max Ø 2100 mm

Référence: 33/3

Rotor blade pouch 3-blade Ø 2500 mm

Référence: 97/4

Servo linkage set

When you build your first model helicopter you will find all the linkage components required to connect the servos to the mechanics supplied with the RC set (German radio systems only). When you come to installing servos in other models you can use this servo linkage set which contains all the link balls, screws, nuts and screw-fitting pushrod...

Référence: 603/44

Adaptor, aluminium, 36 mm

Component part for fuselages, Ord.No. 6030 or 6031.

Référence: 340/7

Fuselage centre section for Lama

Component part for fuselage Lama, Ord.No. 3300, 3400, and 3401.

Référence: 10/74

Mixer nozzles for 10/75 dispenser

 Content of the package5 pieces

Référence: 3947

Quick-release servo mount

During construction we often need that "third hand", and there are times when it would be really useful to be able to see assemblies from front and rear at the same time.Servo installation is fast and reliable using the quick-release servo mount.The mounting plates are simply positioned either in front of the servo or behind it - whichever is more...

Référence: 3936/1

Y-lead

If you want to operate two servos in parallel from one receiver channel you requires a Y-lead.

Référence: 33/1

Rotor blade pouch 2-blade Ø 2500 mm

bag length: 120 cmmax. blade width: 9.5 cm

Référence: 305/18

Halter Kugellager

Référence: 3935/4

Servo extension lead 700 mm

When extending servo cables take into account that cable lengths over 500 mm requires a suppressor (Ord.No. 1040) to avoid interference.