Heat reflective mat

Référence: 755/26

Foam rubber sleeve

Batteries, receiver etc. are very safe in the front structure if they are packed in a foam sleeve.Many hard landings will cause no damage. The same applies to your electronic units provided that they are cossetted in a shock-absorbing foam sleeve.You just cut off the length you require.Inner diameter: 35 mmFoam rubber sleeve, approx. 250 mm

Référence: 755/29

Elastic velcro for battery attachment

length: 30 cmPack of 2

Référence: 9/21

Damping material

  Damping material approx. 60 x 250 mm self-adhesive pad for electronics and installation of tanks

Référence: 1408

Textile cable protection sleeve

A practical method of protecting cables in any model helicopter. This textile-reinforced sleeve protects cables very effectively when they have to be bundled together inside the mechanics; typically servo and extension leads.Length: 1 m

Référence: 755/31

Adhesive velcro pads 20 x 20 mm

Self adhesive velcro padsdimensions: 20 x 20 mm

Référence: 15/4

High current connectors 6 mm

High current bullet connectors 6 mmincluding heat shrink sleeves

Référence: 742/42

Cable tie 360 mm black

Cable ties have a versatile use: they fasten fuel pipes in the right position, they fasten your training undercarriage to the skids, they tidy cables and they even hold fuel tanks and batteries. Contents of each pack 10 pieces available in different length 100 mm black 100 mm white 200 mm black 200 mm white 360 mm black

Référence: 10/85

Hook-and-loop tape 30 x 500 mm

Self-adhesive hook-and-loop tape gives good support to batteries, receivers etc. Components which are fastened with it can be put in and out as often as you like. The joins are not damaged in this process. Pilots in the cockpit can be fitted to their seats with a "cushion" made of this tape. blacknormal stick

Référence: 1409

cable clamp

The cable holder can be fixed over the eyelet. then wrap the sheathed metal strap around the cable.Length: 32 mmPack of 10

Référence: 809/2

Gyro/receiver plate

A good method of mounting your gyro or your receiver is to use this aluminium plate.

Référence: 742/35

Cable tie 100 mm black

Cable ties have a versatile use: they fasten fuel pipes in the right position, they fasten your training undercarriage to the skids, they tidy cables and they even hold fuel tanks and batteries. Contents of each pack 10 pieces available in different length 100 mm black 100 mm white 200 mm black 200 mm white 360 mm black

Référence: 10/2

Heat shrink sleeve set

Heat-shrink sleeving is a highly versatile material, and is useful for aerial joints, wire tailskids, and as security for transmitter strap clips. Heat shrink sleeve set 2 mm, 3.1 mm and 5.5 mm Ø, two of each, 25 cm long Tip For absolute water and dust proof protection of patch cables use a larger heat shrink sleeve over the patch cable and fill both...

Référence: 15/3

High-current connector set

useful for battery packs for electric helicopters

Référence: 742/40

Cable tie 200 mm black

Cable ties have a versatile use: they fasten fuel pipes in the right position, they fasten your training undercarriage to the skids, they tidy cables and they even hold fuel tanks and batteries. Contents of each pack 10 pieces available in different length 100 mm black 100 mm white 200 mm black 200 mm white 360 mm black

Référence: 742/38

Doppelseitiges Klebeband 19 mm

Référence: 28/17

Banana plugs

Banana plugs red and black Pack of 2