Scale-Zubehör Lama Turbine

Référence: 341/445

Pedales llama x2 1: 4

Référence: 341/420

Batterie Lama 1:4

dimensions: 3.2 x 5.25 x 7.75 cm

Référence: 330/2

Turbine factice GFK

The dummy turbine provides the ideal starting point if you wish to install additional scale fittings on your Lama.The dummy turbine is assembled from six separate GRP mouldings, and fits all models with VR-22 mechanics installed.In the turbine-powered version of the Lama the actual turbine is located in this position.GRP dummy turbineLength approx. 490 mm

Référence: 341/508

Petit reservoir d'huile Lama 1:4

dimensions: 5.45 x 1.66 x 5.36 cm

Référence: 341/417

Retroviseur grand Lama 1:4

dimensions: 4 x 5.4 x 1 cm

Référence: 134/410

Antena superior 1: 4

Référence: 330/5

Kit accessoires portes Bell 47 G III, Lama

Door fittings for large-scale model helicopters do not differ fundamentally from one type to another. However, the size of these accessories is important if the model is to look convincing, otherwise they will look out of scale.Compare the door handle of the Lama with that of the Alouette II, and the difference is obvious.The door fittings set for the...

Référence: 341/403

Trappes de visite avant Lama 1:4

dimensions: 6 x 8.2 x 0.5 cm2-part

Référence: 341/412

Entrée l'air turbine 1:4

dimensions: 8 x 3.5 x 4.3 cm

Référence: 134/444

Winch connections 1:4

dimensions:flat: 1.53 x 1.53 x 0.7 cmhigh: 1.29 x 1.29 x 1.14 cmPackage contains: 3x flat + 4x high

Référence: 340/29

Cockpit for Lama, turbine version

Référence: 31/34

Kit manches à balai

Les manches à balai et le levier de Pas font partie des équipements de base de chaque cockpit.La version illustrée correspond à ceux utilisés dans l'hélicoptère grandeur Schweizer 300 C....

Référence: 341/418

Reinforcements for skis Lama 1:4

Référence: 340/1

Support de roue pour Lama

The Lama is a large helicopter, and the supplementary wheels which can be attached to the landing gear make it much easier to move the machine into and out of the hangar. However, the wheels are removed prior to flying the model. These wheel holders for our model of the Lama are made of plastic and are simply glued to the 20 mm Ø skid tubes using UHU...

Référence: 1/21

Casque pour Pilote William 1:4

As you would expect, we can also supply the matching type of GRP helmet for William the Pilot; it is simply pushed into place on his head. If you wish to fit a radio headpiece, you now have plenty of scope for your imagination: a piece of foam rubber, a thin wire mount and a coiled cable are all you need to make this accessory, and the pilot will...

Référence: 341/413

Essuie glace 1:4

dimensions: 10.63 x 0.7 x 1.3 cmPack of 2, each 2-part