Exhaust, stainless steel

Référence: 530/17

Tapa de escape Ø 55 mm

Référence: 342/16

Exhaust for Gazelle

Not available

Référence: 144/16

Exhaust for EC 145 Turbine

stainless steelfor turbine 

Référence: 791/16

Exhaust tube for turbine, Cobra

Exhaust tubes for turbines are always designed for the specified model. It is important that no forward thrust emerges from the system. Should this still occur, the forward thrust produced is minimal.Turbine exhaust tubes are designed as exhaust-gas diffusers, i.e. opens wider towards the rear.

Référence: 344/16

Exhaust for "Starwood" Lama

Not available

Référence: 120/16

EC 120 turbine exhaust pipe

Not available

Référence: 904/16

Exhaust tube for turbine, Hughes

The shape and dimensions of the Hughes fuselages allow for the installation of a three outlet exhaust. The outlets on the left and right hand sides offer the necessary cross-section and greatly reduce the forward thrust. This keeps the scale rear outlet while only discharging a small amount of the total exhaust gas.

Référence: 412/16

Stainless steel exhaust

Not available

Référence: 268/16

Exhaust for XL-C

Exhaust tubes for turbines are always designed for the specified model. It is important that no forward thrust emerges from the system. Should this still occur, the forward thrust produced is minimal.Turbine exhaust tubes are designed as exhaust-gas diffusers, i.e. opens wider towards the rear.

Référence: 134/16

Exhaust tube for turbine, EC 135

On the EC the forward thrust is eliminated by the scale division of the exhaust tube (enlarging of the cross-section) and exhausting up through the rotor disc.

Référence: 9/26

Ceramic band 50x3x1000 mm

Not available

Référence: 206/16

Exhaust for UH-1D

This exhaust system is designed for the UH-1D with turbine power system.Exhaust tubes for turbines are always designed for the specified model. It is important that no forward thrust emerges from the system. Should this still occur, the forward thrust produced is minimal.Turbine exhaust tubes are designed as exhaust-gas diffusers, i.e. opens wider towards...

Référence: 302/16

Exhaust, stainless steel

Exhaust system for Alouette II

Référence: 214/16

Exhaust for Bell 212 Twin Jet

Exhaust tubes for turbines are always designed for the specified model. It is important that no forward thrust emerges from the system. Should this still occur, the forward thrust produced is minimal.Turbine exhaust tubes are designed as exhaust-gas diffusers, i.e. opens wider towards the rear.

Référence: 25/9

Heat reflective mat

Between fuselage and exhaust tube a heat-reflecting mat avoids melting of the fibreglass. Even in smaller fuselages where conventional silencer systems are close to the inside surface, the heat reflective mat is useful as a heat shield.Heat reflective matheat rejectingsize approx. 300 x 700 mmmat thickness approx. 3 mm

Référence: 930/16

Exhaust gas efflux for Mil Mi-2

right / leftThis exhaust system is designed for the Mil Mi-2 with turbine power system.