Bugia para ZG23

Référence: 4321

Suppressed plug cap for petrol engine G230 / G240

Suppressed plug cap to protect the radio control system from potential interference caused by the ignition system

Référence: 13/25

Válvula de llenado para metanol y bencina

Référence: 13/27

Carenado de la válvula de llenado

Référence: 1023/5

On-board electric starter for petrol engine G230 / G240

For the installation of the on-board starter you just remove the pull-cord starter and replace the fan by a modified one.The on-board starter Ord.No. 1023/5 is useful for the petrol engine G230 only.For the previous engine series of ZG 22 and ZG 23 you can use the on-board starter with Ord.No. 1023/6.This on-board electric starter does not fit in the...

Référence: 1023/11

Carburator for benzine motor

Not available

Référence: 830/67

Cooling fan for petrol engine

This additional fan supports the cooling system of the petrol engine and at the same time the air is drawn constantly out of the fuselage.

Référence: 1023/1

Throttle lever for petrol engine G230 / G240

Not available

Référence: 834/38

Motor support kit for G230

With the aid of this set the mechanics gets a significant support because it avoids mechanical twisting caused by the engine.We leave it to your own discretion to convert existing petrol mechanics.

Référence: 830/68

Filtre à essence, mailles fines

Chemical analysis used in Formel 1 is able to determine 1 g of impurity within 1 ton of oil. To fulfill your demand on the cleanness of the fuel for your model helicopter you use the fine-mesh petrol filter inside the fuel tubing between the tank and the carburettor. Also suitable for kerosine turbine fuel.

Référence: 1022/3

High-performance spark plug for petrol engine G230 / G240

The ignition spark of a spark plug occurs between two electrodes (multiple agent alloying on nickel base). The spark plug gap varies considerably depending on the application.

Référence: 9/25

Estera reflectante de calor

Référence: 830/3

Cooling fan puller for the G230 petrol engine

If you wish to install an electric on-board starter on a petrol engine, you will need to remove the existing cooling fan and replace it with a different one. The fan can only be removed using a puller.If you don't have the right tool, removing the fan often turns out to be a difficult task.We have designed the fan puller specifically for this purpose, so...

Référence: 1022/13

Carburettor intake trumpet

This screw-fitting carburettor intake trumpet is designed to improve the flow of air entering the carburettor. Complete with screws and gasket.