Extension torreta 109 mm Aluminio

Riferimento: 808/61

Electric side frame, CFRP

carbon

Riferimento: 1006/15

Scatola ingranaggi principale in alluminio

This is what we recommend to ensure a transfer of power of today’s electric motors with their torque:a new aluminium main gear box Ord.No. 1006/15 steel internal tooth gear with matching clutch bell Ord.No. 36/48.

Riferimento: 860/64

Toothed belt clutch bell 36-tooth

Toothed belt clutch bell, aluminium36-toothtwin ballracedincl. clutch lining

Riferimento: 36/11

Bush 10 x 14 x 2.5 mm

The freewheel hubs are sealed on both sides by brass rings; the rings can also be replaced when necessary (i.e. when the freewheel bearings are replaced).Pack of 2

Riferimento: 71/6

Bush 4 x 6 x 27.7 mm

Pack of 2

Riferimento: 860/25

Bush 3.1 x 8 x 11.1 mm

Pack of 2

Riferimento: 607/53

Set plato ciclico BO 105 T-Rex

Riferimento: 49/55

Yoke connector, shaft 5 mm

This slotted connection shaft holds the loop of the 2 mm tail drive wire. Like all other tail drive systems it is necessary to install "play" (approx. 1 mm) for the wire. Yoke connector5 mm diameter shaft

Riferimento: 37/16

Housing cover aluminium

Not available

Riferimento: 641/54

Bearing support 19 mm

Not available

Riferimento: 53/18

Dome fittings set for GPH 70 turbine

Swashplate/main shaft adaptor for GPH 70 turbine

Riferimento: 36/48

Steel internal tooth gear

Steel internal tooth gear with matching clutch bellexternal diameter: 59 mmfor 10 mm shaft

Riferimento: 61 A

Boccola 3 x 4 x 12,1 mm

Pack of 4

Riferimento: 830/19

Bush 8 x 12 x 10.5 mm

Pack of 1

Riferimento: 54/6

Annular clamp ring / speed sensor

When you use a speed regulator you put the magnets into the cut-outs of this clamp ring. Clamp ring for speed collection, 10 mm Ø.

Riferimento: 603/42

Mechanics support, rear

Mechanics support, rear, aluminium Content of the package: 2 piece