Marcas

Ninguna marca

Referencia: 060

Bulon 3.5 mm - M 2.0 x 5.0

Reseña(s): 0

Estos pernos de punta esférica ofrecen una conexión óptima entre un brazo de salida de servo GRP y la varilla de empuje a la mecánica. Debajo del brazo de salida, bloquea el perno de bola con una tuerca hexagonal M 2. Para brazos de salida de aluminio, utiliza pernos de punta esférica. 060/7 y fluido de bloqueo de hilo.

Precio 13,80 €
Más
En venta bajo pedido
Los productos más vendidos

Soporte GRP

17/4
Valoración 
GRP soporte
10,30 €
Impuestos incluidos En venta bajo pedido
Cantidad
En venta bajo pedido

 

Política de seguridad

 

Política de envío

 

Política de devolución

Descripción
GRP soporte
Detalles del producto
17/4
Reseñas

No hay reseñas de clientes en este momento.

Escriba su propia reseña

Soporte GRP

Soporte GRP

GRP soporte
Escriba su propia reseña
16 altri prodotti della stessa categoria:

Riferimento: 13/21

Magnets for speed regulator

Recensioni: 0

These magnets are suitable for use with all commercial speed regulators. For installation in the mechanics it is advisable the magnets be glued in a clamp ring Ord.No. 54/6, or as in the photo on the internal-tooth gear ring. Pack of 3

Prezzo 9,50 €
Più
In vendita su richiesta

Riferimento: 74

O-ring 3 x 8 mm hard

Recensioni: 0

O-ring 3 x 8 mm hard Content of the package: 4 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Prezzo 3,90 €
Più
In vendita su richiesta

Riferimento: 3948

Servo numbers

Recensioni: 0

Cable spaghetti? We all know the problem of allocating the servo leads to the receiver outputs. Here's the answer: number them like the pro's do! Simply put the receiver channel number on each lead; they can be removed just as easily. The pack contains three sets of 10, numbered from 0-9, in different colours.Servo numbers, pack of 30

Prezzo 9,10 €
Più
In vendita su richiesta

Riferimento: 3942

Servo packer

Recensioni: 0

Servo packing pieces are used with direct-linked JR / Graupner roll-axis servos to give clearance to the pitch-axis servo. Pack of 10

Prezzo 5,60 €
Più
In vendita su richiesta

Riferimento: 33/20

Rotor blade support

Recensioni: 0

An easy solution to the transport problem: This rotor blade support fits all helicopter trainers with 20 mm O.D. tail booms.Rotor blade supportfor rotor blades up to 65 mm chord

Prezzo 11,70 €
Più
In vendita su richiesta

Riferimento: 18/10

PTFE tube for tail drive shaft

Recensioni: 0

PTFE is used as a bearing for the 2 mm wire tail drive shaft (Ord.No. 17) or as a support guide for the 2 mm piano wire push rod (Ord.No. 21 and 800/12) Length: approx. 740 mm

Prezzo 11,50 €
Più
In vendita su richiesta