Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Reference: 68/50
Swashplate driver, metal4 ballracesweigth approx. 25.8 gsuitable for 12 mm Ø main shafts
Reference: 68/54
The swashplate disc can be controlled by 4 ball-end bolts at 90° or by 3 ball-end bolts at 120°, whether the linkage is direct to the servos or utilises bellcranks. As standard there are 4 linkage points.In both types the swashplate bolt assumes the additional function of one linkage point.
Reference: 68/20
Where a pitch compensator sits and two pushrods connect to the flybar, this is now a swashplate driver in its place.This is necessary to drive the inner ring of the swashplate in order to always control the blade angle in the same position.Aluminium swashplate driver with 4 ballraces.
Reference: 68/15
The swashplate disc can be controlled by 4 ball-end bolts at 90° or by 3 ball-end bolts at 120°, whether the linkage is direct to the servos or utilises bellcranks. As standard there are 4 linkage points.In both types the swashplate bolt assumes the additional function of one linkage point. For a 120° linkage the ball-end bolts have to be replaced with...
Reference: 832/68
The use of a mechanics with 12 mm Ø main shaft requires a swashplate with an appropriate swivel ballrace.
Reference: 68/56
Six-blade rotor heads also call for new thinking in swashplate technology.This swashplate is designed to provide more space between the pushrods and the swashplate driver compared to rotor heads with a smaller number of blades.
Reference: 52/20
The swashplate guide prevents the outer ring of the swashplate rotating; the swashplate pin runs in the slot in this guide. The part is fixed to the dome plate using M 3 socket-head cap screws. The length of the swashplate guide slot allows generous collective pitch travels to be exploited to the full; its position on the rotor shaft can be adjusted to...
Reference: 68/52
Swashplate driver, especially for a 5-blade rotor head. "for 12 mm main rotor shaft"
Reference: 68/100
Swashplate set for conversion from 10 mm to 12 mm
