Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Política de seguridad
Política de envío
Política de devolución
Gehäusedeckel lang für Alu-Heckrotor mit Ø 6 mm Welle und Gehäuseverlängerung
No hay reseñas de clientes en este momento.
Référence: 95/10
Not available
Référence: 92/36
Aluminium cover for tail rotor housing for aluminium tail rotor with 6 mm shaft.
Référence: 97/5
The linkage of the tail rotor is affected by the face clearance of servo gears, by the bellcrank and by the pushrod. Minimal play can arise from the face clearance of the servo gears as well as from the necessary freedom of movement for the ball at the bellcrank.With the screw fitting pushrod connector the pushrod still is adjusted without play. The face...
Référence: 92/10
The advantage of this 2-part tail rotor housing is that the gearbox can be checked just by removing the rear housing shell. When adjusting the meshing clearance of the bevel gears and similar settings please keep closely to the building instructions; for lubrication use titanium grease; Ord.No. 10/36.The tail rotor is a vital and highly stressed component...
Référence: 95/11
Not available
Référence: 103/20
Changing from a 2-blade tail rotor to a 3-blade version is quick and affordable if you use our complete blade holder set. The set includes all the components you need, including blade holder, thrust bearing, ballraces, ball-end bolt, screws etc., without 3-blade hub.
Référence: 92/37
Housing cover for aluminium tail rotor with 6 mm shaftaluminium
Référence: 054
Bolt using self-locking nuts don't need additional screw-retaining fluid. Of course this applies to the blade holder bolts on the main rotor head and on the tail rotor (as shown here). Blade holder bolts are counted among the special bolts with high tensile stength, where the shaft and thread length are matched to the application. Pack of 2 with...
Référence: 100/12
Ball linkspack of 2shortconnection with ball-end bolts
