

Ninguna marca
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Reference: 800/50
When you are attempting high-speed flying in reverse and also certain pirouettes you may find that the helicopter's heading changes due to the influence of the solid vertical stabiliser. That is the basic reason for the development of this special 3-D tail.It is very strong, and its large size removes the need for a tail skid. The stabiliser is...
Reference: 118/62
It's a simple matter to clip the still / video camera landing gear underneath any model helicopter, and you're ready to start taking still or video pictures from the air. You will need a little...
Reference: 800/25
If you fit a large stabiliser to your trainer there is no need for a tail skid. This stabiliser provides the tail rotor blades with enough ground clearance, and offers good flight stability at low airspeeds. There are two versions with different methods of attachment.275 mm high118 g total weightscrew fitting to tail rotor holder
Reference: 800/5
Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight
Reference: 870/105
Toothed belt, pitch 5for X-Treme trainer helicoptersWhen replacing a toothed belt please note that different toothed belts are used in X-Treme mechanics and X-Treme trainer helicopters.
Reference: 260/17
Centre bearing setincluding 2 O-ringsexcluding ballrace