Referencia: 92/91
Rodamiento con orejuela de 6 x 10 x 3 mm
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Política de seguridad
Política de envío
Política de devolución
Kühlluftschacht für Modelle aus der X-Treme Serie, GFK, 4teilig.
No hay reseñas de clientes en este momento.
Référence: 7/10
Content of the package2 pieces
Référence: 800/24
If you fit a large stabiliser to your trainer there is no need for a tail skid. This stabiliser provides the tail rotor blades with enough ground clearance, and offers good flight stability at low airspeeds. There are two versions with different methods of attachment.height 275 mm118 g total weightwith clamp for 20 mm Ø tail booms
Référence: 310/8
GRP tuned pipe holders are used to secure the tuned pipe to the tail booms. They are easy to clamp in place. The tail pipe of the tuned pipe should be covered with silicone hose (Order No. 116/8), or with one of the tail pipes (Ord.No. 116/0 or 116/9), so that the heat of the pipe does not damage the holder.Tuned pipe holder, 2-partfor 20 mm ��tail boom
Référence: 800/5
Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight
Référence: 800/23
Component part for stabiliser set, Ord.No. 800/25
Référence: 118/62
Piloter un hélicoptère avec un train d'atterrissage pour photo et vidéo est un peu inhabituel, mais pas un problème en soi pour un pilote expérimenté. Ce train d'atterrissage peut être...
Référence: 800/37
The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.
Référence: 800/55
Stabiliser set laminated of carbon2-part - extra lightweight!For installation at all trainers when the stabiliser holder Ord.No. 870/17 is present.250 mm high19.5 g total weight