Filtro ventilacion de combustible

Reference: 13/32

Kerosene refuelling system

The kerosene refuelling system is sealed with a rubber nipple. The constant low pressure inside the tank draws the nipple firmly against the refuelling opening. That is also the reason why a mechanism such as a spring-controlled valve is not suitable, because the low pressure tends to push the spring back as spring tension diminishes.

Reference: 13/25

Válvula de llenado para metanol y bencina

Reference: 830/83

Petrol fuel tubing 1 m

Fuel tubing for petrolapprox. 1 mtransparentFuel tubing inevitably suffers from the effects of ageing. Always replace brittle tubing before it gives problems! 

Reference: 26/1

Fuel tubing plug

Fuel tubing plug pack of 3

Reference: 10/82

Schlauch für Methanol 1 m

Reference: 26/5

Tank for Kerosene 1.25 l

Tank for Kerosene, 1250 ml, 2 x required for the Lama

Reference: 26/100

Benzin kit incl. fuel tank 540 ccm

Not available

Reference: 791/27

Internal fueltank for Cobra, 2.2 l.

The internal fueltank for our model of the Cobra enables the builder to produce a military version of the machine.The capacity of 2.2 l. gives flight times of around 12 - 14 minutes.

Reference: 302/26

Fuel tank for Kerosin 1,5 l

Fuel tank for Kerosin 1,5 l

Reference: 26/2

Rubber cap

Rubber cap useful to seal fuel lines on the pit box or fuel tank nipples pack of 4

Reference: 3720

Filling station for petrol 3 l capacity

This refuelling station for petrol helicopters consists of a petrol-proof container of 3 litres capacity, a hand-pump for filling and emptying, fittings and filler hose.

Reference: 26/50

Kevlartank for Kerosene 1.4 l

Aramid is a fibre that is used in motor racing. The tanks have an even surface inside and rough on the outside. These fuel tanks are all pressure tested to make sure that they are 100% leak-proof when they arrive at your workshop. They fit in every fuselage, that would normally use the plastic tank Ord.No. 26/5 for. For example, this Aramid tank is...

Reference: 830/27

Tank 540 ml for kerosene

Tank 540 ml, kerosene-resistantincluding accessories complying the special request of the contact with keroseneThe CofG of a model helicopter should only be checked with an empty fuel tank.During the flight the fuel is situated in a place where the additional weight does not have an adverse effect. If you set the CofG with a full fuel tank the resultant...

Reference: 830/68

Fine-mesh petrol and kerosine filter

Chemical analysis used in Formel 1 is able to determine 1 g of impurity within 1 ton of oil. To fulfill your demand on the cleanness of the fuel for your model helicopter you use the fine-mesh petrol filter inside the fuel tubing between the tank and the carburettor. Also suitable for kerosine turbine fuel.

Reference: 26/30

Felt clunk pick-up

Felt clunk pick-up 16 Ø x 26 mmfor bubbles-free suck up and constant flow ofpetrol and kerosene

Reference: 116/5

Fuel tank nipple / Pressure nipple M 5

Content of the packag: 1 piececomplete as shown