Habitaculo Bateria Lama 1:4

Reference: 341/412

Turbine air entry 1:4

dimensions: 8 x 3.5 x 4.3 cm

Reference: 134/410

Antena superior 1: 4

Reference: 134/411

Antena alrededor de 1: 4

Reference: 341/414

Lama 1: 4 luz anticolisión trasera

Reference: 330/2

Dummy turbine, GRP

The dummy turbine provides the ideal starting point if you wish to install additional scale fittings on your Lama.The dummy turbine is assembled from six separate GRP mouldings, and fits all models with VR-22 mechanics installed.In the turbine-powered version of the Lama the actual turbine is located in this position.GRP dummy turbineLength approx. 490 mm

Reference: 134/444

Winch connections 1:4

dimensions:flat: 1.53 x 1.53 x 0.7 cmhigh: 1.29 x 1.29 x 1.14 cmPackage contains: 3x flat + 4x high

Reference: 341/403

Front acces panel Lama 1:4

dimensions: 6 x 8.2 x 0.5 cm2-part

Reference: 341/407

Oil tank large Lama 1:4

dimensions: 6.5 x 4.5 x 6.,5 cm2-part

Reference: 341/405

Pitot tube 1:4

dimensions: 5.7 x 1.7 x 2.5 cm

Reference: 340/5

Snowboards for Lama

When full-size helicopters have to land in deep snow, the skids are fitted with "snowboards" to prevent them sinking in.On the model they look really good, and also help the pilot detect the model's orientation in the air.Make your model an eye-catcher and use some rivets for the decoration of the skies."Snowboards" for Lama, 1 pair

Reference: 341/509

Lama BTP 1:5

dimensions: main part: 9.5 x 4.95 x 6.4 cm6-part

Reference: 341/411

Llama estabilización trasera 1: 4

Reference: 340/1

Wheel holder for Lama

The Lama is a large helicopter, and the supplementary wheels which can be attached to the landing gear make it much easier to move the machine into and out of the hangar. However, the wheels are removed prior to flying the model. These wheel holders for our model of the Lama are made of plastic and are simply glued to the 20 mm Ø skid tubes using UHU...

Reference: 341/413

Wiper, 1:4,2

dimensions: 10.63 x 0.7 x 1.3 cmPack of 2, each 2-part

Reference: 1/21

Helmet for pilot William 1:4

As you would expect, we can also supply the matching type of GRP helmet for William the Pilot; it is simply pushed into place on his head. If you wish to fit a radio headpiece, you now have plenty of scope for your imagination: a piece of foam rubber, a thin wire mount and a coiled cable are all you need to make this accessory, and the pilot will...

Reference: 31/34

Joystick set

The control column and collective pitch stick are part of the basic equipment of any helicopter's cockpit.The version shown here is based on the fittings found in the full-size Schweizer 300 C...