Luces de posicion Lama x2 1:4

Riferimento: 341/407

Serbatio Olio, Lama, 1:4

dimensions: 6.5 x 4.5 x 6.,5 cm2-part

Riferimento: 341/445

Pedales llama x2 1: 4

Riferimento: 341/413

Wiper, 1:4,2

dimensions: 10.63 x 0.7 x 1.3 cmPack of 2, each 2-part

Riferimento: 330/31

Finestratura a boccia, Lama

Bubble window for Lama Ord.No. 3300 / 3400 / 3401, Rotor ø 2500 mm

Riferimento: 341/420

Vano Batteria, Lama, 1:4

dimensions: 3.2 x 5.25 x 7.75 cm

Riferimento: 134/444

Connessioni verricello, 1:4

dimensions:flat: 1.53 x 1.53 x 0.7 cmhigh: 1.29 x 1.29 x 1.14 cmPackage contains: 3x flat + 4x high

Riferimento: 340/13

Finta trasmissione

This dummy power unit can be installed on turbine powered helicopters to produce an even more realistic intersection between the turbine and the gearbox.When the imitation rotor brake of the dummy part is pushed over the turbine starter, the rubber connector is spring-loaded in front of the gearbox connection; retaining screws are not required.Dummy power...

Riferimento: 341/429

Pannello Cockpit dettagliato, LAMA

Addition to the Cockpit Ord. No. 340/29 to make it look more realistic

Riferimento: 341/508

Serbatio olio piccolo Lama 1/4

dimensions: 5.45 x 1.66 x 5.36 cm

Riferimento: 330/10

Protezione capottina per Lama

This protective sheath provides effective protection to the cabin of your valuable helicopter, and helps to avoid unsightly scratches. It is simply pulled over the cabin and closed with a hook -and-loop fastener.Cabin sheath for Lamamatching the cabins of the models 3300 and 3400

Riferimento: 341/416

Espejo Lama 1: 4

Riferimento: 341/421

Rueda de ventilador Lama 1: 4

Riferimento: 340/6

Pedana di salita per Lama

If you have a mind to continue adding detail fittings to your Lama, you are sure to appreciate this landing gear step which can be fitted to an existing model at any time. The step is made of stainless steel, and is supplied complete with clips, screw fittings and tread material. Entry step, for Lama, pack of 1

Riferimento: 134/411

Antena alrededor de 1: 4

Riferimento: 340/1

Supporti ruota per Lama

The Lama is a large helicopter, and the supplementary wheels which can be attached to the landing gear make it much easier to move the machine into and out of the hangar. However, the wheels are removed prior to flying the model. These wheel holders for our model of the Lama are made of plastic and are simply glued to the 20 mm Ø skid tubes using UHU...

Riferimento: 1/21

Helmet for pilot William

As you would expect, we can also supply the matching type of GRP helmet for William the Pilot; it is simply pushed into place on his head. If you wish to fit a radio headpiece, you now have plenty of scope for your imagination: a piece of foam rubber, a thin wire mount and a coiled cable are all you need to make this accessory, and the pilot will...