90 degree link

Reference: 702/96

Inertia weights

set of 2

Reference: 10/91

Silicone sleeve 8 x 2 x 100 mm

Content of the package: 1 piece

Reference: 704/33

4-blade centre piece 12 mm

Component part for a multi-blade rotor head for 12 mm Ø main shaft; see Ord.No. 703/32, 704/32 resp. 705/32.

Reference: 480/53

Co-rotating dome coverage-set

You can fit to your Chinook heads a plate each that covers the dome and spins with the rotor head rpm. A pretty detail, that also can be found on the original Chinook helicopters. The plates / dome covers are mounted on the clamp rings of the main shafts.Pack of 2 plates incl. mounting material

Reference: 10/81

Silicone sleeve 5 x 7 x 100 mm

 Silicone sleeve5 x 7 x 100 mmtransparent

Reference: 54/16

Clamp ring pitch compensator 17 mm

The 17 mm Ø clamp ring is fitted to the rotor head centre piece, the steel pin slides in the guide slot of the pitch compensator. Rotate the clamp for fine adjustment so that your helicopter flies straight when you apply a pitch-axis command.Clamp ring for pitch compensator 17 mm Ø, length of the pin 30 mm.

Reference: 91/67

Heat shrink for paddles

Heat shrinkapprox. 0.5 m, alone

Reference: 80/20

Control bridge 2-part metal, 4 mm

Control bridge 2-part metal, for 4 mm Ø flybar.

Reference: 703/340

Washer for fastening multi-blade head

Not available

Reference: 704/31

4-blade centre piece, 10 mm

Item to a multi-blade rotor head for Ø 10 mm shaft; see Ord.No. 703/30, 704/30 and 705/30.

Reference: 79/8

Inertia weights for Ø 5 mm flybar

Inertia weights are small "extra brakes". They increase the gyroscopic stability of the flybar and slow down the rotor head's response. For every beginner we recommend these so the responsiveness of the rotor head is reduced. The rotor head becomes more responsive as the inertia weights are moveded inwards (always place equally!). Inertia weights suitable...

Reference: 54/18

Clamp ring for 12 mm

Same design as clamp ring 54/13, but for 12 mm Ø main rotor shaft.Clamp ring for pitch compensator 12 mm Ø, length of the pin 40 mm.

Reference: 71 A

Centre piece for pitch compensatorOrd.No. 71 A

Centre piece for pitchcompensator, GFK, alone.

Reference: 82/54

Stabilizer rods 4 x 120 mm

Stabilizer rods 4 x 120 mm Content of the package: 2 pieces

Reference: 704/39

cabezal de rotor de 4 palas 15 mm

Reference: 74/20

O-ring 3 x 11 mm, for CSS rotor head

O-ring 3 x 11 mm for CSS rotor head Content of the package: 2 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.