O-ring 1,5 x 11 mm soft

Riferimento: 72/40

Rotor head centre piece

Aluminium centre piece for 10 mm main shaft

Riferimento: 1005/6

Conversion set for Delta head

In the world of full-size helicopters the Delta effect is universally acknowledged. For model helicopter rotors we have emulated the effect as closely as possible.As soon as a rotor blade is pushed out of its path by some external influence (thermal, down draught etc.) the opposite blade counters the movement and thereby subdues the rotor disc.Conversion...

Riferimento: 76/20

Blade holder set, aluminium

On all 2-blade rotor heads up to 1800 mm rotor disc different blade holders can be mounted.Blade holder set, for one blade holder

Riferimento: 73/10

Albero porta pale 8 x 110 mm

 Thrust bearing shaft8 Ø x 110 mm

Riferimento: 72/10

Corpo centrale bipale

Rotor head centre piece for 2-bladed rotor head.

Riferimento: 704/33

4-blade centre piece 12 mm

Component part for a multi-blade rotor head for 12 mm Ø main shaft; see Ord.No. 703/32, 704/32 resp. 705/32.

Riferimento: 71 A

Corpo centrale, compensatore di passo

Centre piece for pitchcompensator, GFK, alone.

Riferimento: 74/16

O-ring 2 x 12 mm soft

O-ring 2 x 12 mm soft Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Riferimento: 1005/8

Kit de conversión varillaje directo para JetRanger XL eléctrico

Riferimento: 79/13

Flybar stainless steel 4 x 560 mm

The length of the flybar itself also plays an important role in the model's flight characteristics: the longer the flybar, the smoother the hover. A longer flybar increases the control deflections. 450 mm length is considered normal, while 510 mm provides more docile handling.

Riferimento: 704/31

4-blade centre piece, 10 mm

Item to a multi-blade rotor head for Ø 10 mm shaft; see Ord.No. 703/30, 704/30 and 705/30.

Riferimento: 71/26

Forcelle nylon trascinatore

Curved link Content of the package: 2 pieces

Riferimento: 79/8

Inertia weights for Ø 5 mm flybar

Inertia weights are small "extra brakes". They increase the gyroscopic stability of the flybar and slow down the rotor head's response. For every beginner we recommend these so the responsiveness of the rotor head is reduced. The rotor head becomes more responsive as the inertia weights are moveded inwards (always place equally!). Inertia weights suitable...

Riferimento: 72/5

Rotor brake, GRP

When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments.Please note: stay in safe distance away from the turning...

Riferimento: 78/41

Mixer lever cranked

Mixer lever, content of the package 1 piece.Additionial accessories for the use of mixer levers are either two flanged ballraces or two flanged bushes from Delrin as a low cost alternative. The screwing on the blade holder arm complies with the kind of hole, i.e. it depends on the through hole or on the blind hole. Please note for choosing the screws:...

Riferimento: 76/25

Blade holder, blade grip 18 mm

Not available