Stabilizer rods 4 x 120 mm

Référence: 71/4

Pièce centrale en alu Ø 10 mm

Pitch mixer centre piece, aluminium, 10 mm ∅

Référence: 78/40

Kit mélangeurs

Mixer levers are an essential part of every flybar-controlled rotor head. From the swashplate a pushrod runs to the ballraced mixer arm which is screwed to the blade holder arm. The mixer levers transmit the control movement to the flybar via the double ball-link.Additionial accessories for the use of mixer levers are either two flanged ballraces or two...

Référence: 74/20

O-ring 3 x 11 mm, for CSS rotor head

O-ring 3 x 11 mm for CSS rotor head Content of the package: 2 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Référence: 78/41

Mixer lever cranked

Mixer lever, content of the package 1 piece.Additionial accessories for the use of mixer levers are either two flanged ballraces or two flanged bushes from Delrin as a low cost alternative. The screwing on the blade holder arm complies with the kind of hole, i.e. it depends on the through hole or on the blind hole. Please note for choosing the screws:...

Référence: 79/13

Flybar stainless steel 4 x 560 mm

The length of the flybar itself also plays an important role in the model's flight characteristics: the longer the flybar, the smoother the hover. A longer flybar increases the control deflections. 450 mm length is considered normal, while 510 mm provides more docile handling.

Référence: 74/12

O-ring 3 x 12 mm hard

O-ring 3 x 12 mm hard Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Référence: 72/18

Rotor head centre piece, rigid

Aluminium centre piece, rigid, for 10 mm main shaft

Référence: 1005/8

Kit de conversión varillaje directo para JetRanger XL eléctrico

Référence: 76/15

Porte-pales GFK

Blade holder, GRP, reinforced

Référence: 702/79

Flybar stainless steel 5 x 270 mm

Pack of 2

Référence: 702/92

Rotor head balance weight Bell 47 black

Not available

Référence: 832/54

Clamp ring

Clamp ring for rotor head 722/72.

Référence: 832/55

Clamp ring, mixing base

Clamp ring for pitch compensator

Référence: 74/21

O-ring 3.5 x 12 mm hard

O-ring 3.5 x 12 mm hard Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Référence: 76/19

GRP blade holder, 5 mm ∅ hole

As demands on helicopters continue to rise, so stronger blade holders are required. In this case a 14 mm blade holder is combined with a 5 mm Ø hole for blade retention, i.e. the matching blade holder screws and self-locking nuts are M5 in size.GRP blade holder with short linkage armfor multi-blade rotor heads

Référence: 72/40

Rotor head centre piece

Aluminium centre piece for 10 mm main shaft