

No brand
Référence: 2017 E
Référence: 97/4
When you build your first model helicopter you will find all the linkage components required to connect the servos to the mechanics supplied with the RC set (German radio systems only). When you come to installing servos in other models you can use this servo linkage set which contains all the link balls, screws, nuts and screw-fitting pushrod...
Política de seguridad
Política de envío
Política de devolución
Aucun avis n'a été publié pour le moment.
Riferimento: 71/4
Pitch mixer centre piece, aluminium, 10 mm ∅
Riferimento: 78/40
Mixer levers are an essential part of every flybar-controlled rotor head. From the swashplate a pushrod runs to the ballraced mixer arm which is screwed to the blade holder arm. The mixer levers transmit the control movement to the flybar via the double ball-link.Additionial accessories for the use of mixer levers are either two flanged ballraces or two...
Riferimento: 480/53
You can fit to your Chinook heads a plate each that covers the dome and spins with the rotor head rpm. A pretty detail, that also can be found on the original Chinook helicopters. The plates / dome covers are mounted on the clamp rings of the main shafts.Pack of 2 plates incl. mounting material
Riferimento: 74/5
O-ring 3 x 7 mm soft Content of the package: 4 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.
Riferimento: 87/4
A 90° twisted double ball-link connect the mixer lever to the ball collet on the flybar. Content of the package: 2 pieces
Riferimento: 832/71
Pitch mixer centre piece, aluminium, 12 mm Ø
Riferimento: 72/4
When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments.Please note: stay in safe distance away from the turning...
Riferimento: 54/13
On longer rotor shafts the clamp ring for the pitch compensator sits underneath of the centre piece directly on the rotor shaft.Clamp ring for pitch compensator 10 mm Ø, length of the pin 30 mm.
Riferimento: 72/45
Aluminium centre piece for 12 mm Ø main shaft
Riferimento: 707/5
The multi-blade rotor heads of full-size helicopters are generally fitted with protective covers; this applies to the Ecureuil, the Dauphin, the Eurocopter EC 135 and 145, the MD Hughes, etc. Rotor head covers also look good on your model, and we stock them with indentations corresponding to the number of blade grips. The covers are made of CFRP and can...
Riferimento: 703/31
Item to a multi-blade rotor head for Ø 10 mm shaft; see Ord.No. 703/30, 704/30 and 705/30.
Riferimento: 76/18
Component part for a multi-blade rotor head for 10 mm or 12 mm Ø main shaft.