Tirant pour moteur

Riferimento: 809/24

Kühlluftschacht Skyfox, rauchglas

Riferimento: 800/24

Stabilizzatore grande

If you fit a large stabiliser to your trainer there is no need for a tail skid. This stabiliser provides the tail rotor blades with enough ground clearance, and offers good flight stability at low airspeeds. There are two versions with different methods of attachment.height 275 mm118 g total weightwith clamp for 20 mm Ø tail booms

Riferimento: 800/5

Stabilizzare il set rosso

Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight

Riferimento: 7/57

70 mm M 3 estudios

 Content of the package1 piece

Riferimento: 260/7

Supporto del braccio posteriore

Tail boom holder XLV.

Riferimento: 870/16

Leitwerkadapter, 2-teilig

Riferimento: 21/7

Conjunto estabilizador negro

Riferimento: 260/11

Set stabilizzatore, XLV

GRP Stabiliser set for XLV Trainer.

Riferimento: 800/19

Coda skid bianca

Tail skids only. Create your own individual colour scheme: e.g. white stabiliser - red skid!

Riferimento: 260/17

Set cuscinetto centrale

 Centre bearing setincluding 2 O-ringsexcluding ballrace

Riferimento: 809/12

M 4 Verschraubung

Riferimento: 800/50

Stabilizzare 3-D, fibra di carbonio

When you are attempting high-speed flying in reverse and also certain pirouettes you may find that the helicopter's heading changes due to the influence of the solid vertical stabiliser. That is the basic reason for the development of this special 3-D tail.It is very strong, and its large size removes the need for a tail skid. The stabiliser is...

Riferimento: 30/7

Strut set fibra de carbono 8 x 200 mm

Riferimento: 809/7

Heckrohrhalter 20 mm

Riferimento: 800/37

Supporto per tettuccio da 26 mm

The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.

Riferimento: 810/5

Kufenauflage