Elastic velcro for battery attachment

Reference: 809/2

Gyro/receiver plate

A good method of mounting your gyro or your receiver is to use this aluminium plate.

Reference: 10/2

Heat shrink sleeve set

Heat-shrink sleeving is a highly versatile material, and is useful for aerial joints, wire tailskids, and as security for transmitter strap clips. Heat shrink sleeve set 2 mm, 3.1 mm and 5.5 mm Ø, two of each, 25 cm long Tip For absolute water and dust proof protection of patch cables use a larger heat shrink sleeve over the patch cable and fill both...

Reference: 742/38

Doppelseitiges Klebeband 19 mm

Reference: 1406

Cable spiral tubing

Cables which could chafe somewhere on the model are best run in this flexible spiral tubing – it keeps the cables well protected. It doesn't matter whether there are two or six servo cables, the cable spiral tubing expands round the cables keeping the installation neat. Each pack has 1 m length. transparent

Reference: 1408

Textile cable protection sleeve

A practical method of protecting cables in any model helicopter. This textile-reinforced sleeve protects cables very effectively when they have to be bundled together inside the mechanics; typically servo and extension leads.Length: 1 m

Reference: 15/3

High-current connector set

useful for battery packs for electric helicopters

Reference: 3503

RC connector retainer

Extension cable plugs should not loosen themselves or even come apart. The safety clip for RC-plug connections guarantees permanent contact. Pack of 2

Reference: 742/36

Cable clips self-adhesive

Cable clips made of soft aluminium in strips of four. The double-sided sticky tape adheres very well to smooth surfaces, for example on the vertical plates of the side frames. Servo cables can be routed neatly in the clips.Pack of 4

Reference: 742/41

Cable tie 200 mm white

Cable ties have a versatile use: they fasten fuel pipes in the right position, they fasten your training undercarriage to the skids, they tidy cables and they even hold fuel tanks and batteries. Contents of each pack 10 pieces available in different length 100 mm black 100 mm white 200 mm black 200 mm white 360 mm black

Reference: 1409

cable clamp

The cable holder can be fixed over the eyelet. then wrap the sheathed metal strap around the cable.Length: 32 mmPack of 10

Reference: 742/35

Cable tie 100 mm black

Cable ties have a versatile use: they fasten fuel pipes in the right position, they fasten your training undercarriage to the skids, they tidy cables and they even hold fuel tanks and batteries. Contents of each pack 10 pieces available in different length 100 mm black 100 mm white 200 mm black 200 mm white 360 mm black

Reference: 809/3

CFRP gyro/receiver plate

The ideal method of mounting your gyro or your receiver is to use this carbon fibre plate with its reinforced cross-piece.

Reference: 25/9

Heat reflective mat

Between fuselage and exhaust tube a heat-reflecting mat avoids melting of the fibreglass. Even in smaller fuselages where conventional silencer systems are close to the inside surface, the heat reflective mat is useful as a heat shield.Heat reflective matheat rejectingsize approx. 300 x 700 mmmat thickness approx. 3 mm

Reference: 755/26

Foam rubber sleeve

Batteries, receiver etc. are very safe in the front structure if they are packed in a foam sleeve.Many hard landings will cause no damage. The same applies to your electronic units provided that they are cossetted in a shock-absorbing foam sleeve.You just cut off the length you require.Inner diameter: 35 mmFoam rubber sleeve, approx. 250 mm

Reference: 742/42

Cable tie 360 mm black

Cable ties have a versatile use: they fasten fuel pipes in the right position, they fasten your training undercarriage to the skids, they tidy cables and they even hold fuel tanks and batteries. Contents of each pack 10 pieces available in different length 100 mm black 100 mm white 200 mm black 200 mm white 360 mm black

Reference: 28/17

Banana plugs

Banana plugs red and black Pack of 2