JetRanger big 1:6 - Fuselage kit

Référence: 108/0

Autocollant Jet Ranger III

Les autocollants avec insignes spécifiques, immatriculation et consignes, sont imprimés sur un film transparent. Découpez les différents motifs avec un cutter et une règle métallique (réf....

Référence: 104/30

Kit verrières big Jet Ranger bleues

 big Jet Ranger glazing setbluenot trimmed

Référence: 104/31

Kit verrières big Jet Ranger

 big Jet Ranger glazing setclearnot trimmed

Référence: 104/33

Vitres supérieures big Jet Ranger

 big Jet Ranger upper windowsgreennot trimmed

Référence: 26/100

Benzin kit incl. fuel tank 540 ccm

Not available

Référence: 830/68

Filtre à essence, mailles fines

Chemical analysis used in Formel 1 is able to determine 1 g of impurity within 1 ton of oil. To fulfill your demand on the cleanness of the fuel for your model helicopter you use the fine-mesh petrol filter inside the fuel tubing between the tank and the carburettor. Also suitable for kerosine turbine fuel.

Référence: 830/83

Durite d'essence 1m

Fuel tubing for petrolapprox. 1 mtransparentFuel tubing inevitably suffers from the effects of ageing. Always replace brittle tubing before it gives problems! 

Référence: 70/101-2

Tringle 3,0 x 100 mmOrd.No. 70/101-2

Ready-made pushrod, threaded M 3. Pack of 2

Référence: 107/49

Chappe pour tige de 3 mm et bille de 4.8 mm

Pack of 25

Référence: 104/50

Door set left big Jet Ranger

Component part for fuselage big Jet Ranger, Ord.No. 1004.

Référence: 104/51

Door set right big Jet Ranger

Component part for fuselage big Jet Ranger, Ord.No. 1004.

Référence: 104/2

GRP top cover 2pc, big Jet Ranger

Component part for fuselage big Jet Ranger, Ord.No. 1004.

Référence: 104/11

Stabiliser set big Jet Ranger

GRP3-partfor Jet Ranger with a length up to approx. 1800 mm

Référence: 104/32

Tail cap big Jet Ranger

 Tail cap big Jet RangerGRP

Référence: 104/1

Skid landing gear for big Jet Ranger

Skid landing gear for big Jet Rangeroriginal kit accessoriescomplete as shown

Référence: 104/3

Bulkhead set big Jet Ranger

Component part for fuselage big Jet Ranger, Ord.No. 1004.

Référence: 1002/21

Petrol mechanics 90:18

Référence: 830/101

Electric Benzin Conversion Kit, 6mm shaft

Benzin-Trainer to electric conversion?..why not! Here is a rather simple way to convert your Benzin Trainer to electric power. Remove the Petrol motor and exhaust and replace it with an electric motor of your choice. The motor mount retrofit set can be used with the most common electric motors. This conversion set can also be used with the Benzin fuselage...

Référence: 116/95

Silencer system

 Silencer systemIntake pipe 170 mmSilencer chamber 195 mmOverall Ø 50 mmManifold: 34 mm hole spacingTail pipe length 80 mmWeight approx. 390 g

Référence: 4321

Suppressed plug cap for petrol engine G230 / G240

Suppressed plug cap to protect the radio control system from potential interference caused by the ignition system

Référence: 1023/5

On-board electric starter for petrol engine G230 / G240

For the installation of the on-board starter you just remove the pull-cord starter and replace the fan by a modified one.The on-board starter Ord.No. 1023/5 is useful for the petrol engine G230 only.For the previous engine series of ZG 22 and ZG 23 you can use the on-board starter with Ord.No. 1023/6.This on-board electric starter does not fit in the...

Référence: 419

2-blade-set 1810 mm

Specification 2-blade-set length: 815 mm rotor disc: 1810 mm blade root: 14 mm 1-hole blade chord: 72 mm profile thickness: 9 mm weight: ca. 260 g material: CFRP Shark Skin finish: anthracite matt symmetry: reflex l.h.r.

Référence: 33/2

Rotor blade pouch 2-blade Ø 2100 mm

bag length: 98 cmmax. blade width: 9.5 cm

Référence: 68/20

Swashplate driver 10 mm

Where a pitch compensator sits and two pushrods connect to the flybar, this is now a swashplate driver in its place.This is necessary to drive the inner ring of the swashplate in order to always control the blade angle in the same position.Aluminium swashplate driver with 4 ballraces.

Référence: 34/30

Tail rotor blades 130 mm

Tail rotor bladesSpecification 8.0 mm blade root8.7 g approx.29 mm blade chord5.0 mm profile thicknesssymmetrical130 mm longbalanced1 pair

Référence: 1/16

Pilot Gerald, 300 mm

Pilot Geraldbody height 300 mm weight approx. 164 ggrey overall

Référence: 1/60

Pilot Sebastian, 300 mm

Pilot Sebastianheight : 300 mm

Référence: 995

RC system accessories incl. 5 servos

If you already own a radio control system and then purchase a second model helicopter, the next step is to consider carefully which electronic components are the best choice for the new model.The combination illustrated here comprises accessories which have proved excellent in practice. RC system accessories, with Futaba BLS 452 servos excluding radio...

Référence: 14/76

Car sticker Jet Ranger silver

Car stickers show everyone immediately that you are a member of the helicopter scene. These stickers are factory-trimmed, and make it possible to transfer only the finely cut lines onto the base surface you have choosen. The stickers adhere very well, and do not fade.Color: silverSize approx. 80 x 200 mm

Référence: 5/104

Coffee mug JETRANGER small

Not available

Référence: 706/20

6-Blatt Rotorkopf für Ø 12 mm Welle

Référence: 104/8

Rumpfmittelteil Jet Ranger 1004

Référence: 104/24

Luftkanal 2teilig, Jet Ranger 1004

Référence: 135/30

Scheibensatz EC 135