Rear canopy holder XLV

Reference: 810/4

Transverse link 47 mm

The required length of the transverse link is determined by the kind of canopy and the location of its fitting points on the side frames.Pack of 2

Reference: 808/3

Canopy holder 26 mm

The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.

Reference: 800/40

Quick-release canopy set

One of the main reasons for the popularity of the "trainer" type of model helicopters is their excellent all-round access to the mechanics once the canopy has been removed.The icing on the cake is to fit our quick-release canopy retainers, because then you don't even need to use screws to retain the canopy. The three small openings in the centre and on...

Reference: 860/1

Decal sheet X-Perience

Reference: 800/42

Canopy ball-end bolts M 4

 Content of the package 2 piecesComponent part for the quick-release canopy set Ord.No. 800/40

Reference: 830/60

Canopy holder 58 mm

The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.

Reference: 855/1

Decal sheet Sky Fox SX

Reference: 809/1

Decal sheet Sky Fox

Reference: 871/1

Decal sheet X-Treme

Reference: 875/1

Decal sheet X-Treme economic

Reference: 802/1

Decal sheet 4-Takt Boxer

Reference: 808/5

Canopy holder 37 mm

The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.

Reference: 800/39

Sliding cabin holder, alone

Sliding cabin holder, alone.

Reference: 870/1

Decal sheet X-Treme

Reference: 830/1

Decal sheet Benzin Trainer

Reference: 808/0

Decal sheet Silence