Charge lead MPX high current plug 2.5 mm²

Riferimento: 13/21

Magnets for speed regulator

These magnets are suitable for use with all commercial speed regulators. For installation in the mechanics it is advisable the magnets be glued in a clamp ring Ord.No. 54/6, or as in the photo on the internal-tooth gear ring. Pack of 3

Riferimento: 33/5

Rotorblatttasche 5-Blatt max Ø 2500 mm

Riferimento: 33/25

Soporte de la del rotor

Riferimento: 97/9

Screw fitting pushrod connector

Screw fixing pushrod connectors can be used on bell-cranks and servo output arms at the tail rotor servo, so that the tail rotor pushrod can quickly be installed, disconnected and adjusted. A further advantage is that a hardened steel pushrod can be used. For one helicopter you need two pushrod connectors.Caution during installation: the barrel of the...

Riferimento: 18/11

Aluminium tube 5.5 x 4.4 x 1000 mm

Aluminium tube 5.5 x 4.4 x 1000 mm

Riferimento: 1413

Electronic switch harness

Not available

Riferimento: 33/28

Rotor blade tie-down

Rotor blade tie-downs are an essential feature of full-size helicopter life. The tie-down protects the blades from swinging, rocking and stretching, and thereby prevents excessive pressure on the rotor shaft. If these measures were not taken the result could easily be in-flight mechanical failure; rotor blades spinning as the wind rises could strike...

Riferimento: 3944

Servo mount 120°

When using a 4-point-linkage, the linkages from the servos run in a straight line to the swashplate.A 3-point-linkage does not permit this, here the linkages run diagonally.The 120° servo mounting enables inclined installation of the servos, and the results are straight running linkages to the swashplate.All Sky Fox based mechanics as well as on the...

Riferimento: 603/19

Adaptor, tail boom rear, GRP

Component part for fuselages, Ord.No. 6030 or 6031.

Riferimento: 17/4

GRP bracket

 Content of the package1 piece

Riferimento: 33/4

Rotor bolsa de cuchillas 4 cuchillas Ø 2500 mm

Riferimento: 3936/1

Y-lead

If you want to operate two servos in parallel from one receiver channel you requires a Y-lead.

Riferimento: 333/5

Rotor blade pouch 5-blade Ø 2500 mm

bag length: 120 cmmax. blade width: 9.5 cm

Riferimento: 3942

Servo packer

Servo packing pieces are used with direct-linked JR / Graupner roll-axis servos to give clearance to the pitch-axis servo. Pack of 10

Riferimento: 603/16

Tail boom set, Schweizer 300 C

Component part for fuselages, Ord.No. 6030 or 6031.

Riferimento: 18/1

PVC tube 3.0 x 2.0 x 980 mm, red

PVC tube 3.0 x 2.0 x 980 mm, red