Split taper collet 8 mm
11,40 €
Tasse incluse
Split taper collet 8 mm
A split taper collet has to be assembled so that it fits tightly onto the crankshaft of the engine.
If there are problems sliding the split taper collet easily onto the crankshaft, please insert a screwdriver into the slot and try to open it gently. It should now slide onto the shaft without a problem.
- material: brass
- fits the glow plug motor clutch
A split taper collet has to be assembled so that it fits tightly onto the crankshaft of the engine.
If there are problems sliding the split taper collet easily onto the crankshaft, please insert a screwdriver into the slot and try to open it gently. It should now slide onto the shaft without a problem.
Split taper collet 8 mm
A split taper collet has to be assembled so that it fits tightly onto the crankshaft of the engine.
If there are problems sliding the split taper collet easily onto the crankshaft, please insert a screwdriver into the slot and try to open it gently. It should now slide onto the shaft without a problem.
- material: brass
- fits the glow plug motor clutch
A split taper collet has to be assembled so that it fits tightly onto the crankshaft of the engine.
If there are problems sliding the split taper collet easily onto the crankshaft, please insert a screwdriver into the slot and try to open it gently. It should now slide onto the shaft without a problem.
64/5
Riferimenti Specifici
- ean13
- 2321101309303
Commenti (0)
Ancora nessuna recensione da parte degli utenti.
Split taper collet 8 mm
A split taper collet has to be assembled so that it fits tightly onto the crankshaft of the engine.
If there are problems sliding the split taper collet easily onto the crankshaft, please insert a screwdriver into the slot and try to open it gently. It should now slide onto the shaft without a problem.
- material: brass
- fits the glow plug motor clutch
A split taper collet has to be assembled so that it fits tightly onto the crankshaft of the engine.
If there are problems sliding the split taper collet easily onto the crankshaft, please insert a screwdriver into the slot and try to open it gently. It should now slide onto the shaft without a problem.