Home
Marchi

Nessuna marca

Fornitori
Migliori vendite
Flanged ballrace 6 x 10 x 3 mm Anteprima

Riferimento: 92/91

Flanged ballrace 6 x 10 x 3 mm

Recensioni: 0

Ballraces are used wherever moving parts are required to run with a minimum of play and a minimum of friction. The more ballraces are used, the more smoothly the mechanics of a helicopter works, and the lower the rate of wear. The dimensions of a ballrace mean: inside diameter (I.D.) x outside diameter (O.D.) x thickness. For flanged bearings the same...

Prezzo 14,70 €
Più
In vendita su richiesta
Tutte le migliori vendite

Four-screw fixing, shaft 5 mm

49/9
Valutazione 



Contrary to common opinion steel wires should only be degreased before mounting, but not sanded. This would cause running out-of-centre.
After the change steel drive wire you should not use the grubscrews anymore. The max. force originates each with starting (turning up the system), i.e. over a longer period the shaft leaves it's marks on the surfaces of the grubscrews. If these will be in use again tiny rolled-in grooves might be formed.
The drive wire is no longer held between the screws, a tail rotor failure has been caused.

  • Tail rotor connection
  • four-screw fixing, 5 mm ∅ shaft
27,40 €
Tasse incluse
Quantità
In vendita su richiesta

 

Política de seguridad

 

Política de envío

 

Política de devolución

Descrizione



Contrary to common opinion steel wires should only be degreased before mounting, but not sanded. This would cause running out-of-centre.
After the change steel drive wire you should not use the grubscrews anymore. The max. force originates each with starting (turning up the system), i.e. over a longer period the shaft leaves it's marks on the surfaces of the grubscrews. If these will be in use again tiny rolled-in grooves might be formed.
The drive wire is no longer held between the screws, a tail rotor failure has been caused.

  • Tail rotor connection
  • four-screw fixing, 5 mm ∅ shaft
Dettagli del prodotto
49/9
Recensioni

Ancora nessuna recensione da parte degli utenti.

Scrivi la tua recensione

Four-screw fixing, shaft 5 mm

Four-screw fixing, shaft 5 mm



Contrary to common opinion steel wires should only be degreased before mounting, but not sanded. This would cause running out-of-centre.
After the change steel drive wire you should not use the grubscrews anymore. The max. force originates each with starting (turning up the system), i.e. over a longer period the shaft leaves it's marks on the surfaces of the grubscrews. If these will be in use again tiny rolled-in grooves might be formed.
The drive wire is no longer held between the screws, a tail rotor failure has been caused.

  • Tail rotor connection
  • four-screw fixing, 5 mm ∅ shaft
Scrivi la tua recensione
16 otros productos en la misma categoría:

Seguici su Facebook

Facebook