Kit cloche con pedali

Référence: 340/13

Transmission factice

This dummy power unit can be installed on turbine powered helicopters to produce an even more realistic intersection between the turbine and the gearbox.When the imitation rotor brake of the dummy part is pushed over the turbine starter, the rubber connector is spring-loaded in front of the gearbox connection; retaining screws are not required.Dummy power...

Référence: 341/424

Kick bar llama 2 partes 1: 4

Référence: 341/414

Lama 1: 4 luz anticolisión trasera

Référence: 134/444

Winch connections 1:4

dimensions:flat: 1.53 x 1.53 x 0.7 cmhigh: 1.29 x 1.29 x 1.14 cmPackage contains: 3x flat + 4x high

Référence: 341/411

Llama estabilización trasera 1: 4

Référence: 340/40

Kit rétroviseurs pour grands modèles

Mirror set, complete as illustratede.g. for Lama and other large-scale modelsdimensions of the mirrors: approx. 40 x 84 and 14 x 22 mm

Référence: 340/29

Cockpit for Lama, turbine version

Référence: 341/407

Grand reservoir d'huile Lama 1:4

dimensions: 6.5 x 4.5 x 6.,5 cm2-part

Référence: 1/21

Casque pour Pilote William 1:4

As you would expect, we can also supply the matching type of GRP helmet for William the Pilot; it is simply pushed into place on his head. If you wish to fit a radio headpiece, you now have plenty of scope for your imagination: a piece of foam rubber, a thin wire mount and a coiled cable are all you need to make this accessory, and the pilot will...

Référence: 341/420

Batterie Lama 1:4

dimensions: 3.2 x 5.25 x 7.75 cm

Référence: 10/96

Anti-collision light with red housing

Référence: 341/417

Retroviseur grand Lama 1:4

dimensions: 4 x 5.4 x 1 cm

Référence: 340/1

Support de roue pour Lama

The Lama is a large helicopter, and the supplementary wheels which can be attached to the landing gear make it much easier to move the machine into and out of the hangar. However, the wheels are removed prior to flying the model. These wheel holders for our model of the Lama are made of plastic and are simply glued to the 20 mm Ø skid tubes using UHU...

Référence: 30/50

Extincteur, longueur env. 70 mm

Fire extinguishers in the cockpit are mandatory for any scale model helicopter, since the full-size machines are also required to carry them.Our fire extinguisher is available in two different sizes, and it can be mounted in the cockpit in a wide variety of positions.For models up to 2000 mm rotor diameter we recommend the smaller version; the bigger one...

Référence: 341/415

Llamada de rescate por radar x2 1: 4

Référence: 341/36

Panier de transport, 1 pièce

Load basket for Lamalength:410 mmwidth:100 mmheight70 mm