Collet 4 mm

Référence: 54/14

Clamp ring 12 mm for rotor shaft

The clamp ring below the dome plate secures the rotor shaft inside the mechanics. Pay attention to achieve a safe installation, because the complete model is hanging on this clamp ring! Clamp ring for rotor shaft 12 mm Ø

Référence: 340/31

Hub gear 130 teeth

Not available

Référence: 54/6

Annular clamp ring / speed sensor

When you use a speed regulator you put the magnets into the cut-outs of this clamp ring. Clamp ring for speed collection, 10 mm Ø.

Référence: 722/15

Lay shaft 10 x 252 mm

 Lay shaft10 diameter x 252 mm

Référence: 57/20

Pitch-axis crank set

 Content of the packagecomplete as shown

Référence: 61 A

Douille 2,1 x 3 x 5,5 mm

Pack of 4

Référence: 412/53

Dome fittings set 4-blade T-Rex Bell 412

Not available

Référence: 870/50

Front vertical frame, X-Treme

Not available

Référence: 54/9

Clamp ring 10 mm diameter rotor shaft

Below the dome plate you install the clamp ring with the socket on top if no thrust bearing is mounted. The socket supports the clamp ring against the inner ring of the ballrace - otherwise the clamp ring would grind on the outer ring, and affect the function of the ballrace.Clamp ring for rotor shaft, 10 mm diameter

Référence: 132/38

Fixation pièce II pour transmission

These parts are used in a petrol Fenestron mechanical system for mounting the gearbox, where the rotational speed of the tail drive shaft (Ord.No. 134/37) has to be increased. Bracket for speed-up gearboxPack of 2, incl. mounting material

Référence: 102

Douille 3 x 5 x 2,6 mm

Pack of 2

Référence: 53/15

Dome fittings set for PHT3

Bell cranks/main shaft adaptor for JetCat Turbine, for 2-blade main rotor head

Référence: 105/49

Butée Ø10

Ø10 x 2,5 mmContent of the package: 2 pieces

Référence: 49/16

Retaining spring

If your helicopter accidentally makes ground contact, the claw coupling may disengage, and the cruciform element may be lost. Fitting an annular retaining spring ensures exact alignment of the claw coupling, and prevents the cruciform element slipping out.  Retaining springpack of 2

Référence: 607/53

Set plato ciclico BO 105 T-Rex

Référence: 53/19

Dome fittings set for PHT3-L

Dome fittings set for JetCat PHT3-L turbine