Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Référence: 105/43
Strut holder, square bar, aluminium Content of the package: 2 piece
Référence: 53/17
Dome fittings set for JetCat PHT3-3 turbine
Référence: 54/14
The clamp ring below the dome plate secures the rotor shaft inside the mechanics. Pay attention to achieve a safe installation, because the complete model is hanging on this clamp ring! Clamp ring for rotor shaft 12 mm Ø
Référence: 722/9
The rotor of a model like the Robinson R22 can no longer be slowed down by hand. We can supply an optional rotor brake for mouting below the main gear.The installation can be carried out on an already built set of mechanics (without removing the main rotor shaft). The construction is designed so an accidental activation barely impacts the rotor speed...
Référence: 61/20
The ballraced 60° bellcrank, for example, is positioned between the horizontal pushrod from the throttle servo and the pushrod running to the barrel arm on the carburettor. When the arm below the ball is vertical the engine is stopped. When the 60° arm is horizontal the engine is at full throttle.In models with overhead tail rotor (e.g. BK 117, BO 105)...
Référence: 870/200
For the conversion of a L.H. X-Treme trainer into a R.H. mechanics needed parts are assembled in this set. This set contains all the parts required for the conversion of a L.H. X-Treme trainer into R.H. mechanics.
