Mixer nozzles for 10/75 dispenser

Reference: 890/25

Cooling fan support for Schweizer 300 C

Component part for fuselage, Ord.No. 6030 or 6031.

Reference: 340/7

Fuselage centre section for Lama

Component part for fuselage Lama, Ord.No. 3300, 3400, and 3401.

Reference: 3942

Servo packer

Servo packing pieces are used with direct-linked JR / Graupner roll-axis servos to give clearance to the pitch-axis servo. Pack of 10

Reference: 330/18

Gear support for tail drive

Component part for fuselages like Air-Crane, Bell 47 or Lama.Pack of 3

Reference: 33/66

Rotor blade pouch 2x3 blade max Ø 2500 mm

Reference: 33/1

Rotor blade pouch 2-blade Ø 2500 mm

bag length: 120 cmmax. blade width: 9.5 cm

Reference: 17/4

GRP bracket

 Content of the package1 piece

Reference: 603/44

Adaptor, aluminium, 36 mm

Component part for fuselages, Ord.No. 6030 or 6031.

Reference: 33/22

Rotor blade support

If you do not wish to remove the rotor blades temporarily for transport, they can be protected effectively in this strong support, which is mounted above the tail boom.The height of the support, the width of the blade openings and the diameter of the tail boom are the crucial factors when buying a blade support.This support is ideal for pod-and-boom...

Reference: 33/2

Rotor blade pouch 2-blade Ø 2100 mm

bag length: 98 cmmax. blade width: 9.5 cm

Reference: 3935/4

Servo extension lead 700 mm

When extending servo cables take into account that cable lengths over 500 mm requires a suppressor (Ord.No. 1040) to avoid interference.

Reference: 18

PVC tube 3.2 x 2.2 x 1000 mm, white

PVC tube 3.2 x 2.2 x 1000 mm, white

Reference: 18/11

Aluminium tube 5.5 x 4.4 x 1000 mm

Aluminium tube 5.5 x 4.4 x 1000 mm

Reference: 33/27

Rotor blade tie-down large

The rotor blade harness ranks as an essential accessory for full-size helicopters. These items prevent the blades swinging or rocking, and thereby exerting pressure on the rotor shaft. If that were to be allowed, in-flight failures could be attributed to it.Rotor blades set in motion by rising winds could also be damaged by striking obstacles. The rotor...

Reference: 18/10

PTFE tube for tail drive shaft

PTFE is used as a bearing for the 2 mm wire tail drive shaft (Ord.No. 17) or as a support guide for the 2 mm piano wire push rod (Ord.No. 21 and 800/12) Length: approx. 740 mm

Reference: 3947

Quick-release servo mount

During construction we often need that "third hand", and there are times when it would be really useful to be able to see assemblies from front and rear at the same time.Servo installation is fast and reliable using the quick-release servo mount.The mounting plates are simply positioned either in front of the servo or behind it - whichever is more...