- Es gibt keine Artikel mehr in Ihrem Warenkorb
- Versand kostenlos
- Gesamt 0,00 €
- Helikoptermodelle
- Trainer / Zweckhelikopter
- Mechaniken und Zubehör
- Scale-Ausbau
- Nieten
- Innenausbau
- Außenanbauteile
- Mehrblatt-Sätze
- Modellspezifisch
- Agusta AW 139 1:7
- AIRWOLF 2001 1:8
- AIRWOLF 2002/2003 1:7
- AIRWOLF 2004 1:5
- Apache 1:7
- neue 3D-Scaleartikel
- Bell 230/430 1:7
- Bell 412 1:6
- Bell 429 1:5
- Bell UH / 212 / 412 1:5
- Bell UH / 212 / 412 1:7
- EC 120
- EC 135/145 1:4
- EC 135/145 1:6
- Ecureuil 1:4
- Ecureuil 1:6
- Gazelle
- H145 T2
- JetRanger XL
- sonstige Aussenanbauten
- Lama / Alouette II 1:4
- Lama 1:5
- Lama / Alouette II 1:6
- Antrieb und Zubehör
- Transmision/Engranajes
- Rotorköpfe und Zubehör
- Heckrotor
- Rotorblätter
- Werkzeug, Klebstoffe
- Rumpfeinzelteile
- Elektronik
- Kleb- u. Schmierstoffe
- Kugellager$ Befestigung
- Fanartikel$ Nützliches
- Flugfertige Modelle ((A)RTF)
- Fundgrube
- KATALOG
- Earthmovers
- Angebote
- Neue Artikel
- Modelado 3D
Keine Marke
M 4 Verschraubung
Política de seguridad
Política de envío
Política de devolución
Aktuell keine Kunden-Kommentare
Riferimento: 800/37
Supporto per tettuccio da 26 mm
The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.
Riferimento: 800/24
Stabilizzatore grande
If you fit a large stabiliser to your trainer there is no need for a tail skid. This stabiliser provides the tail rotor blades with enough ground clearance, and offers good flight stability at low airspeeds. There are two versions with different methods of attachment.height 275 mm118 g total weightwith clamp for 20 mm Ø tail booms
Riferimento: 800/55
Set stabilizzatore, fibra di carbonio
Stabiliser set laminated of carbon2-part - extra lightweight!For installation at all trainers when the stabiliser holder Ord.No. 870/17 is present.250 mm high19.5 g total weight
Riferimento: 800/50
Stabilizzare 3-D, fibra di carbonio
When you are attempting high-speed flying in reverse and also certain pirouettes you may find that the helicopter's heading changes due to the influence of the solid vertical stabiliser. That is the basic reason for the development of this special 3-D tail.It is very strong, and its large size removes the need for a tail skid. The stabiliser is...
Riferimento: 800/6
Stabilizzatore giallo
Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight