Ballraces are used wherever moving parts are required to run with a minimum of play and a minimum of friction. The more ballraces are used, the more smoothly the mechanics of a helicopter works, and the lower the rate of wear. The dimensions of a ballrace mean: inside diameter (I.D.) x outside diameter (O.D.) x thickness. For flanged bearings the same...
Decal sheet TIGERlettering blackStickers with type specific lettering, registration, and warning notices are printed on clear foil. With ruler and scalpel (Ord.No. 11/59) you will obtain a clean...
Decal sheet TIGERlettering blackStickers with type specific lettering, registration, and warning notices are printed on clear foil. With ruler and scalpel (Ord.No. 11/59) you will obtain a clean cut for individual items out of a sticker. Do not remove the foil with your finger nail, this could stretch the edge of the foil. The tip of the scalpel would best suit your purpose, and you put it on one edge of the sticker, to slide it between the foil and the paper. If it does not work take hold just before the end of the edge with thumb and forefinger. Than quickly move the scalpel with the other hand up and down over the edge. Now it should be no more a problem to pull out the foil easily from the paper. Do not touch the foil on the adhesive side (fingerprints!), but hold it still with the scalpel, until it is fixed in the correct position on the model.
Car stickers show everyone immediately that you are a member of the helicopter scene. These stickers are factory-trimmed, and make it possible to transfer only the finely cut lines onto the base surface you have choosen. The stickers adhere very well, and do not fade.