Ballraces are used wherever moving parts are required to run with a minimum of play and a minimum of friction. The more ballraces are used, the more smoothly the mechanics of a helicopter works, and the lower the rate of wear. The dimensions of a ballrace mean: inside diameter (I.D.) x outside diameter (O.D.) x thickness. For flanged bearings the same...
Painting of a registration is more difficult than painting the complete fuselage. The registration is available in black and white lettering, font size 50 mm, 44 mm and 30 mm, as a complete set....
Painting of a registration is more difficult than painting the complete fuselage. The registration is available in black and white lettering, font size 50 mm, 44 mm and 30 mm, as a complete set. Stickers with type specific lettering, registration, and warning notices are printed on clear foil. With ruler and scalpel (Ord.No. 11/59) you will obtain a clean cut for individual items out of a sticker. Do not remove the foil with your finger nail, this could stretch the edge of the foil. The tip of the scalpel would best suit your purpose, and you put it on one edge of the sticker, to slide it between the foil and the paper. If it does not work take hold just before the end of the edge with thumb and forefinger. Than quickly move the scalpel with the other hand up and down over the edge. Now it should be no more a problem to pull out the foil easily from the paper. Do not touch the foil on the adhesive side (fingerprints!), but hold it still with the scalpel, until it is fixed in the correct position on the model.
Travi di coda in alluminio con spessore 0,8 mm sono realizzati in base alle richieste dei modelli trainer con motori a scoppio. I travi sono fabbricati in modo particolare, sono cioè controllati...
Travi di coda in alluminio con spessore 0,8 mm sono realizzati in base alle richieste dei modelli trainer con motori a scoppio. I travi sono fabbricati in modo particolare, sono cioè controllati...
Travi di coda in alluminio con spessore 0,8 mm sono realizzati in base alle richieste dei modelli trainer con motori a scoppio. I travi sono fabbricati in modo particolare, sono cioè controllati...
Decal sheet MEDICOPTER 117factory-trimmedPre-cut transfer sheets make it much easier to apply a colour finish to your model: Clean the fuselage carefully, separate the individual items from the transfer sheet, leaving them oversize, and cut only the backing film through the centre line of the sticker (do not cut through the sticker!). Position it on the...
TransferGerman flag black-red-golddimensions: 1,5 x 3,0 cm. quantity 2 piecesStickersGerman flag black-red-golddimensions: 2,0 x 3,0 cm. quantity 2 pieces
Painting of a registration is more difficult than painting the complete fuselage. The registration is available in black and white lettering, font size 50 mm, 44 mm and 30 mm, as a complete set....