Snowboards for Lama

Référence: 341/418

Reinforcements for skis Lama 1:4

Référence: 340/29

Cockpit for Lama, turbine version

Référence: 341/412

Entrée l'air turbine 1:4

dimensions: 8 x 3.5 x 4.3 cm

Référence: 341/404

Feux de position Lama x2 1:4

dimensions: 4.5 x 3.2 x 1.8 cmPack of 2 (l/r)

Référence: 341/419

Poulies de cables Lama x6 1:4

1,18 x 3,15 x 0,72 cmPack of 6

Référence: 330/2

Turbine factice GFK

The dummy turbine provides the ideal starting point if you wish to install additional scale fittings on your Lama.The dummy turbine is assembled from six separate GRP mouldings, and fits all models with VR-22 mechanics installed.In the turbine-powered version of the Lama the actual turbine is located in this position.GRP dummy turbineLength approx. 490 mm

Référence: 340/13

Transmission factice

This dummy power unit can be installed on turbine powered helicopters to produce an even more realistic intersection between the turbine and the gearbox.When the imitation rotor brake of the dummy part is pushed over the turbine starter, the rubber connector is spring-loaded in front of the gearbox connection; retaining screws are not required.Dummy power...

Référence: 341/402

Trappe kero Lama N1 1:4

dimensions: 4.3 x 2.5 cm, inner diameter: 1.43 cm

Référence: 341/416

Espejo Lama 1: 4

Référence: 341/406

Boitier électrique Lama 1:4

dimensions: 12.6 x 7 x 4.3 cm2-part

Référence: 330/10

Housse de protection pour Lama

This protective sheath provides effective protection to the cabin of your valuable helicopter, and helps to avoid unsightly scratches. It is simply pulled over the cabin and closed with a hook -and-loop fastener.Cabin sheath for Lamamatching the cabins of the models 3300 and 3400

Référence: 350/45

Treuil, opérationnel

Great fascination is achieved by active working details on scale models, remember e.g. rotary lights and navigation lights.A working winch adds a special attraction on a model helicopter particularly if it is pivoting and fully functional!Especially on a Alouette III you hardly need fantasy, to see instead of the model the full-size helicopter in your...

Référence: 340/2

Accessoires maquette pour Lama turbine

The suckering ducts are on the model exactly on the same place as the original ones in position to the turbine on the full-size helicopter.

Référence: 1/21

Casque pour Pilote William 1:4

As you would expect, we can also supply the matching type of GRP helmet for William the Pilot; it is simply pushed into place on his head. If you wish to fit a radio headpiece, you now have plenty of scope for your imagination: a piece of foam rubber, a thin wire mount and a coiled cable are all you need to make this accessory, and the pilot will...

Référence: 341/407

Grand reservoir d'huile Lama 1:4

dimensions: 6.5 x 4.5 x 6.,5 cm2-part

Référence: 10/96

Anti-collision light with red housing