Marcas

Ninguna marca

Proveedores
Los productos más vendidos

Pasadores con circlip

71/27
Valoración 
Pivote con anillo de seguridad
8,40 €
Impuestos incluidos
Cantidad
En venta bajo pedido

 

Política de seguridad

 

Política de envío

 

Política de devolución

Descripción
Pivote con anillo de seguridad
Detalles del producto
71/27
Reseñas

No hay reseñas de clientes en este momento.

Escriba su propia reseña

Pasadores con circlip

Pasadores con circlip

Pivote con anillo de seguridad
Escriba su propia reseña
16 altri prodotti della stessa categoria:

Riferimento: 76/19

GRP blade holder, 5 mm ∅ hole

Recensioni: 0

As demands on helicopters continue to rise, so stronger blade holders are required. In this case a 14 mm blade holder is combined with a 5 mm Ø hole for blade retention, i.e. the matching blade holder screws and self-locking nuts are M5 in size.GRP blade holder with short linkage armfor multi-blade rotor heads

Prezzo 30,60 €
Più
In vendita su richiesta

Riferimento: 74/20

O-ring 3 x 11 mm, for CSS rotor head

Recensioni: 0

O-ring 3 x 11 mm for CSS rotor head Content of the package: 2 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Prezzo 6,30 €
Più
In vendita su richiesta

Riferimento: 54/16

Clamp ring pitch compensator 17 mm

Recensioni: 0

The 17 mm Ø clamp ring is fitted to the rotor head centre piece, the steel pin slides in the guide slot of the pitch compensator. Rotate the clamp for fine adjustment so that your helicopter flies straight when you apply a pitch-axis command.Clamp ring for pitch compensator 17 mm Ø, length of the pin 30 mm.

Prezzo 27,40 €
Più
In vendita su richiesta

Riferimento: 702/76

GRP blade holder, 22 mm blade throat

Recensioni: 0

This blade holder was specially developed for the large Bell 47 G III with a rotor diameter of 2.36 m. It has a 22 mm blade throat and a 6 mm Ø bore for the retaining screw, i.e. the matching blade holder screws and self-locking nuts are M6 in size.

Prezzo 37,80 €
Più
In vendita su richiesta

Riferimento: 87/20

Actuating lever

Recensioni: 0

The connection between mixer lever and variable rocker is carried out by an actuating lever, triple ballraced. Content of the package: 2 pieces

Prezzo 27,40 €
Più
In vendita su richiesta

Riferimento: 79/8

Inertia weights for Ø 5 mm flybar

Recensioni: 0

Inertia weights are small "extra brakes". They increase the gyroscopic stability of the flybar and slow down the rotor head's response. For every beginner we recommend these so the responsiveness of the rotor head is reduced. The rotor head becomes more responsive as the inertia weights are moveded inwards (always place equally!). Inertia weights suitable...

Prezzo 30,60 €
Più
In vendita su richiesta

Síganos en Facebook