Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Riferimento: 834/53
The rugged aluminium base plate accommodates the complete mechanics assembly of the Acrobatic trainer. For the installation and removal of the engine it is not essential to dismantle the base plate from the side frames.
Riferimento: 36/40
Provided that you maintain your model helicopter conscientiously and set it up according to the instructions, the model's flying load limits are well outside its normal flight envelope.Detail features of the kit are designed to suit normal applications, but different parts can be retro-fitted at any time, e.g. if you wish to convert a Kobold into a...
Riferimento: 54/14
The clamp ring below the dome plate secures the rotor shaft inside the mechanics. Pay attention to achieve a safe installation, because the complete model is hanging on this clamp ring! Clamp ring for rotor shaft 12 mm Ø
Riferimento: 1002/32
If you prefer to mount the tail rotor servo in the mechanics rather than inside the fuselage, this is the accessory you need.
Riferimento: 132/37
These parts are used in a petrol Fenestron mechanical system for mounting the gearbox, where the rotational speed of the tail drive shaft has to be increased.Pack of 2
Riferimento: 53
At the top of the mechanics the dome plate supports the rotor shaft with the help of a 10 x 21 x 5 mm or 12 x 21 x 5 mm ballrace. To reduce the load on the ballrace a thrust bearing can also be fitted under the dome plate.
Riferimento: 907/2
Use this special servo mount for installing the throttle servo on the base plate.
