Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Swashplate / driver / mast lock / plus rods needed for fitting the 3 blade rotor head on the Lama with T-Rex 700E mechanics
Política de seguridad
Política de envío
Política de devolución
Swashplate / driver / mast lock / plus rods needed for fitting the 3 blade rotor head on the Lama with T-Rex 700E mechanics
No hay reseñas de clientes en este momento.
Référence: 870/200
For the conversion of a L.H. X-Treme trainer into a R.H. mechanics needed parts are assembled in this set. This set contains all the parts required for the conversion of a L.H. X-Treme trainer into R.H. mechanics.
Référence: 54/9
Below the dome plate you install the clamp ring with the socket on top if no thrust bearing is mounted. The socket supports the clamp ring against the inner ring of the ballrace - otherwise the clamp ring would grind on the outer ring, and affect the function of the ballrace.Clamp ring for rotor shaft, 10 mm diameter
Référence: 105/44
Adaptor for mechanics bearer, Delrin Content of the package: 4 pieces
Référence: 802/64
32-tooth clutch belldouble ballracedincluding lining
Référence: 61/20
The ballraced 60° bellcrank, for example, is positioned between the horizontal pushrod from the throttle servo and the pushrod running to the barrel arm on the carburettor. When the arm below the ball is vertical the engine is stopped. When the 60° arm is horizontal the engine is at full throttle.In models with overhead tail rotor (e.g. BK 117, BO 105)...
Swashplate / driver / mast lock / plus rods needed for fitting the 3 blade rotor head on the Lama with T-Rex 700E mechanics
