

Ninguna marca
Referencia: 34/38
Palas del rotor de cola Juego de 2 palaslongitud = 130 mmancho = 35 mm13 gsimétricopara portacuchillas con portacuchillas de 5 mm (¡no para portacuchillas Vario!), 1 orificio, Ø 3 mmcompatible con NHP
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Riferimento: 412/49
Ø7 x 2,5 mmContent of the package: 2 pieces
Riferimento: 722/9
The rotor of a model like the Robinson R22 can no longer be slowed down by hand. We can supply an optional rotor brake for mouting below the main gear.The installation can be carried out on an already built set of mechanics (without removing the main rotor shaft). The construction is designed so an accidental activation barely impacts the rotor speed...
Riferimento: 49/55
This slotted connection shaft holds the loop of the 2 mm tail drive wire. Like all other tail drive systems it is necessary to install "play" (approx. 1 mm) for the wire. Yoke connector5 mm diameter shaft
Riferimento: 834/53
The rugged aluminium base plate accommodates the complete mechanics assembly of the Acrobatic trainer. For the installation and removal of the engine it is not essential to dismantle the base plate from the side frames.
Riferimento: 603/42
Mechanics support, rear, aluminium Content of the package: 2 piece
Riferimento: 49/16
If your helicopter accidentally makes ground contact, the claw coupling may disengage, and the cruciform element may be lost. Fitting an annular retaining spring ensures exact alignment of the claw coupling, and prevents the cruciform element slipping out. Retaining springpack of 2
Riferimento: 907/53
Component part for mechanics Ord.No. 1002/27
Riferimento: 105/43
Strut holder, square bar, aluminium Content of the package: 2 piece
Riferimento: 830/51
Fuselage mounting brackets for petrol mechanics, pack of 2,recommended accessories for the installation of a petrol trainer mechanics in a fuselage.