Tiranta para motor

Riferimento: 870/41

Untere Edelstahl-Träger 8 mm

Riferimento: 809/24

Kühlluftschacht Skyfox, rauchglas

Riferimento: 860/120

Toothed belt for X-Perience, 3M/606

Toothed belt for X-Perience. Content of the package: 1 piece.

Riferimento: 860/11

Heckrohrhalter, 2fach kugelgelagert

Riferimento: 890/5

Kufenauflage

Riferimento: 21/7

Conjunto estabilizador negro

Riferimento: 800/50

Stabilizzare 3-D, fibra di carbonio

When you are attempting high-speed flying in reverse and also certain pirouettes you may find that the helicopter's heading changes due to the influence of the solid vertical stabiliser. That is the basic reason for the development of this special 3-D tail.It is very strong, and its large size removes the need for a tail skid. The stabiliser is...

Riferimento: 890/49

Lagerplatte

Riferimento: 800/5

Stabilizzare il set rosso

Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight

Riferimento: 870/105

Toothed belt, pitch T5/340

Toothed belt, pitch 5for X-Treme trainer helicoptersWhen replacing a toothed belt please note that different toothed belts are used in X-Treme mechanics and X-Treme trainer helicopters.

Riferimento: 800/24

Stabilizzatore grande

If you fit a large stabiliser to your trainer there is no need for a tail skid. This stabiliser provides the tail rotor blades with enough ground clearance, and offers good flight stability at low airspeeds. There are two versions with different methods of attachment.height 275 mm118 g total weightwith clamp for 20 mm Ø tail booms

Riferimento: 24/7

Conducto de aire de enfriamiento para foxy

Riferimento: 260/38

Puntone per motore

Strut for motor, XLV.

Riferimento: 870/4

Querverbinder, GFK

Riferimento: 800/6

Stabilizzatore giallo

Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight

Riferimento: 809/7

Heckrohrhalter 20 mm