
Referencia: 92/91
Rodamiento con orejuela de 6 x 10 x 3 mm
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Référence: 3741
Separate pump holder and hand wind pump, suitable for fitting to the 10 L fuel container.
Référence: 26/50
Aramid is a fibre that is used in motor racing. The tanks have an even surface inside and rough on the outside. These fuel tanks are all pressure tested to make sure that they are 100% leak-proof when they arrive at your workshop. They fit in every fuselage, that would normally use the plastic tank Ord.No. 26/5 for. For example, this Aramid tank is...
Référence: 830/27
Tank 540 ml, kerosene-resistantincluding accessories complying the special request of the contact with keroseneThe CofG of a model helicopter should only be checked with an empty fuel tank.During the flight the fuel is situated in a place where the additional weight does not have an adverse effect. If you set the CofG with a full fuel tank the resultant...
Référence: 791/26
Kerosene Tank 1.5 l, GRP, with accessories, for Cobra with Turbine
Référence: 412/26
dimensions: approx. 38.5 x 18 x 4.5 cm (height of the nose: 9 cm)
Référence: 3740
Any turbine-powered model has to carry a very large quantity of fuel, and this in turn calls for a fuel station of ample volume.The VARIO filler station has a capacity of 10 litres and is ideal for flying sessions.The fueltank is filled and drained using a practical geared pump, which is permanently mounted on the fuel container.
Référence: 3720
This refuelling station for petrol helicopters consists of a petrol-proof container of 3 litres capacity, a hand-pump for filling and emptying, fittings and filler hose.
Référence: 26/2
Rubber cap useful to seal fuel lines on the pit box or fuel tank nipples pack of 4