Referencia: 92/91
Rodamiento con orejuela de 6 x 10 x 3 mm
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Como era de esperar, también podemos suministrar el tipo de casco GRP correspondiente para William the Pilot; simplemente es empujado a su lugar en su cabeza.
Si desea colocar un casco de radio, ahora tiene un amplio margen para su imaginación: todo lo que necesita para hacer este accesorio es un trozo de gomaespuma, un soporte de alambre delgado y un cable en espiral, y el piloto apreciará la capacidad de comunicarse correctamente
Política de seguridad
Política de envío
Política de devolución
Casco de piloto Peter
No hay reseñas de clientes en este momento.
Reference: 31/34
The control column and collective pitch stick are part of the basic equipment of any helicopter's cockpit.The version shown here is based on the fittings found in the full-size Schweizer 300 C...
Reference: 350/17
When the turbine of a full-size helicopter is not running, the engine is protected with an exhaust cover which prevents foreign objects finding their way inside the turbine. This exhaust cover for model turbines is suitable for the Lama, Alouette III and any other machine with a 90 mm Ø exhaust pipe. Caution: it is essential to allow the exhaust pipes to...
Reference: 330/5
Door fittings for large-scale model helicopters do not differ fundamentally from one type to another. However, the size of these accessories is important if the model is to look convincing, otherwise they will look out of scale.Compare the door handle of the Lama with that of the Alouette II, and the difference is obvious.The door fittings set for the...
Reference: 340/13
This dummy power unit can be installed on turbine powered helicopters to produce an even more realistic intersection between the turbine and the gearbox.When the imitation rotor brake of the dummy part is pushed over the turbine starter, the rubber connector is spring-loaded in front of the gearbox connection; retaining screws are not required.Dummy power...
Reference: 340/6
If you have a mind to continue adding detail fittings to your Lama, you are sure to appreciate this landing gear step which can be fitted to an existing model at any time. The step is made of stainless steel, and is supplied complete with clips, screw fittings and tread material. Entry step, for Lama, pack of 1
Reference: 341/404
dimensions: 4.5 x 3.2 x 1.8 cmPack of 2 (l/r)
Reference: 330/10
This protective sheath provides effective protection to the cabin of your valuable helicopter, and helps to avoid unsightly scratches. It is simply pulled over the cabin and closed with a hook -and-loop fastener.Cabin sheath for Lamamatching the cabins of the models 3300 and 3400
Reference: 341/402
dimensions: 4.3 x 2.5 cm, inner diameter: 1.43 cm