Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Reference: 17/8
Connecting plug for stainless steel tube 8 mm pack of 2
Reference: 17/75
Stainless steel tail rotor drivefor 25 mm Ø tail boomwith 0.8 mm wall thicknesscomplete as shown
Reference: 17/7
The use of an articulated centre support in helicopters with extreme high mounted tail booms (e.g. Hughes 500) helps to balance up to 30 mm vertical off-set between mechanics and tail rotor. The centre support is double ballraced and pre-assembled.
Reference: 17/14
Of course the explanation of Ord.No. 17/10 concerning a 2 mm steel drive wire in acrobatics applies not only for fuselages, it is similar for training helicopters.When you convert a trainer you use the existing tail boom. Main gearbox and tail gearbox have to be provided with a claw connector 49/12 each.Models over a certain age should be checked whether...
Reference: 17/20
This version of the ballraced tail rotor drive system is designed for installation in full-fuselage models. Power is transmitted by a 6 mm stainless steel drive shaft with a length of 980 mm.This length ensures that the system can be used in virtually all our larger fuselages, provided that the main and tail rotors are fitted with the articulated...
Reference: 17/55
Stainless steel drive for installationin models with 40° angle gearboxcomplete as shown
Reference: 17/15
Stainless steel tube 6.0 x 0.3 x 890 mm
Reference: 17/17
Connecting plug for ø 6 mm tubePack of 2
Reference: 800/9
PTFE guides in the tail boom provide the necessary "lubrication" for the drive shaft, which eliminates the need to oil the system separately.PTFE guide for 0.8 mm tail boomPack of 3
Reference: 17/16
Advanced pilots appreciate the more precise control response of a rigid tail rotor drive system, as provided by a stainless steel drive shaft. Stainless steel tube 6.0 x 0.3 x 950 mm
Reference: 603/17
Component part for fuselages, Ord.No. 6030 or 6031.
Reference: 105/14
Stainless steel tube 8.0 mm2-part (462 mm + 1160 mm)
Reference: 17/13
On a model helicopter like the Hughes 500 e.g. the tail boom is extremely high connected. Therefore an articulated centre support is applied in addition to the articulated tail drive system. The centre support is double ballraced and pre-assembled.Articulated joint tail drive systemwith articulated centre support
Reference: 17/18
Connecting plug for stainless steel tube 5 mm pack of 2
Reference: 945/14
Not available
