Référence: 115/15

Flexible 12 x 170 mm

 Content of the package1 piece

Référence: 59/5

Motor mount for Webra 8 cc

Factory-drilled motor mounts, already drilled and tapped for M 3 or M 4, are available in pairs (left / right). Avoid interchanging the left hand with the right hand one!1 pairfactory-drilled

Référence: 310/2

Tuned pipe holder for fuselages

The shape of a fuselage is not always correct to support the tuned pipe at the exit (e.g. model Tiger).Tuned pipe holder for fuselagesset suitable for tuned pipe 116/16

Référence: 802/47

Hexagon starter socket

Référence: 64/17

Flywheel ø 39.6 x 10.5 mm

Flywheel for clutchouter diameter: 39.6 mmheight: 10.5 mmfits the glow plug motor clutch

Référence: 115/5

Tube PTFE 20 x 2,5 x 120 mm

Manifolds and tuned pipes or silencers must be installed without touching each other, because the contact of these metal parts could cause radio interference. We can refer to this interference as "electric noise". The connection by PTFE pipe enables the required distance of 10 - 15 mm in the prescribed position, and it steadily seals gas-tight. This...

Référence: 310/20

Silencer holder set

  Silencer holder set complete as shown

Référence: 3491

Charger for 12 V starter battery

Use this battery charger to recharge the starter battery; mains connection for 230 V. Charger for 12 V starter battery

Référence: 59/9

Motor support for electric motors

Motor mount for electric motors for installation in the model Silence.

Référence: 116/71

Tuned pipe silencer

 Tuned pipe silenceroverall length 400 mmconnection-Ø 20 mmoverall Ø 40 mmsilencer chamber 240 mmweight approx. 180 gtail pipe length 100 mm

Référence: 64/8

lining 45 x 40 x 12 mm

Friction between the flywheel and the clutch bell result in a certain amount of wear of the clutch lining.For installation you slightly grind one of the outer edges. Afterwards you press the liner with that edge in front into the clutch bell. To glue in a new clutch liner you use e.g. UHU plus endfest 300, Ord.No. 10/26 or 10/27.Fits the glow plug motor...

Référence: 310/25

Tuned pipe holder X-Treme

Engines with rear exhaust enable the installation of the tuned pipe underneath the mechanics of a trainer helicopter, mounted at the mechanics.Depending on the kind of the engine the sizes of the tuned pipes vary in size. The difference of these sets is due to the diameter of the fastening clamp.Tuned pipe holderset suitable for tuned pipe 116/33